chemical structures into substances that are less toxic and/or more readily biodegradable by employing chemical oxidizing agents in the presence of an appropriate catalyst and/or ultraviolet light to oxidize or degrade the pollutant of interest. These technologies known as advanced oxidation processes (AOP) or advanced oxidation technologies (AOT), have been widely studied for the degradation of diverse types of industrial wastewaters. These processes are particularly interesting for the treatment of effluents containing highly toxic organic compounds, for which biological processes may not be applicable unless bacteria that are adapted to live in toxic media are available. The production of powerful oxidizing agents, such as the hydroxyl radical, is the main objective of most AOP. The hydroxyl radical reacts rapidly and relatively non-selectively with organic compounds by hydrogen abstraction, by addition to unsaturated bonds and aromatic rings, or by electron transfer. In the case of persistent organic pollutants (wastes), complete decontamination may require the sequential application of several different decontamination technologies such as a pretreatment with a photochemical AOP followed by a biological or electrochemical treatment.This chapter discusses the influence of different AOP on the degradation and mineralization of several different classes of organic pollutants such as pesticides, pharmaceutical formulations and dyes. The use of the Fenton and photo-Fenton reactions as tools for the treatment of pesticides and antineoplastic agents is presented, as well as examples of the optimization of the important parameters involved in the process such as the source of iron ions (free or complexed), the irradiation source (including the possibility of using sunlight), and the concentrations of iron ions and hydrogen peroxide. The chapter also reports the use of TiO 2 nanotubes obtained by electrochemical anodization, nanoparticles prepared by a molten salt technique, and Ag-doped TiO 2 nanoparticles as heterogeneous photocatalysts, emphasizing their potential for use in environmental applications. These catalysts were characterized by a combination of techniques, including scanning electron microscopy, elemental analysis, and energy dispersive x-ray spectroscopy. Advanced Oxidation Processes (AOP)AOP are specific chemical reactions characterized by the generation of chemical oxidizing agents capable of oxidizing or degrading the pollutant of interest. The efficiency of the AOP is generally maximized by the use of an appropriate catalyst and/or ultraviolet light [1][2][3].In most AOP, the objective is to use systems that produce the hydroxyl radical (HO • ) or another species of similar reactivity such as sulfate radical anion (SO 4 •-). These radicals react with the majority of organic substances at rates often approaching the diffusion-controlled limit (unit reaction efficiency per encounter). Both of these species are thus highly reactive and only modestly selective in their capacity to degrade toxic organi...
CuO nanostructured thin films supported on silicon with 6.5 cm 2 area (geometric area greater than the studies reported in the literature) were synthesized by a chemical bath deposition technique. The electrodes were characterized by MEV, XRD, XPS, contact angle, cyclic voltammetry and electrochemical impedance spectroscopy analyses. To evaluate the photoelectrochemical properties of the CuO films, photocurrent-voltage measurements were performed using linear voltammetry. The catalytic activities of CuO nanostructures were evaluated by monitoring photodegradation of Mitoxantrone (MTX) under UV-A light irradiation. The method of photoelectrocatalysis (PEC), applying a voltage of 1.5 V and assisted by adding H 2 O 2 , was undertaken. To the best of our knowledge, no studies on the degradation of anticancer agents using PEC process have been found in the literature. For comparison purposes, experiments were performed under the same conditions by assisted photocatalysis (PC) with H 2 O 2 and direct photolysis. CuO deposits consists of a needle-like morphology. The presence of CuO in the tenorite phase was evidenced by XRD and the XPS spectra showed the presence of copper(II) oxide. The increase in current under illumination shows that CuO exhibits photoactivity. The PEC system showed a 75% level of MTX degradation, while the level achieved using PC was 50%. Under UV-A light alone only 3% removal was obtained after 180 min. Up to 10 by-products were identified by chromatography-mass spectrometry (LC-MS) with m/z values ranging between 521 and 285 and a plausible degradation route has been proposed. It is worth mentioning that 9 by-products identified in this work, were not found in the literature in other studies of degradation or products generated as metabolites. The toxicity tests of MTX before and after PEC treatment with
ZnO nanorods were grown on silicon (Si) substrates by two techniques: (i) Chemical Bath Deposition (CBD) and (ii) a CBD seed layer combined with Carbothermal Reduction Vapor Phase Transport (CTR-VPT). The structured ZnO nanorods were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and contact angle measurments. The photoelectrochemical property of ZnO nanorods were analyzed by linear voltammetry under UV-ABC light excitation. Using the ZnO nanorod samples as photoanodes, the removal of methylene blue (MB) as a representative organic compound was studied by the photoelectrocatalytic (PEC) technique applying a potential (E) of 0.6 V. For comparison purposes, experiments were performed under the same conditions using photocatalysis (PC), direct photolysis and using samples of pure Si (support material) as working electrodes in PEC. XRD analyses of ZnO prepared by both methods showed the expected ZnO wurtzite phase and a preferred c-axial orientation in the growth of the nanorods. The presence of ZnO was further confirmed by XPS and contact angle measurements showed that ZnO grown by CBD (ZnO/CBD) had a slightly hydrophobic behavior while ZnO grown by CTR-VPT (ZnO/CTR-VPT) is hydrophilic. Both ZnO sample types were shown to be photoactive, 3 with ZnO/CBD showing higher resultant photocurrent compared to ZnO/CTR-VPT. For the degradation of MB 53% of the compound was removed using ZnO/CBD as a working electrode, while using the ZnO/CTR-VPT electrode led to a removal of 43% of MB. However, direct photolysis alone removed 39% of the MB. The lower removal of MB using ZnO/CTR-VPT samples was related to surface dissociation during the degradation process. The results show that ZnO nanorods prepared by the CBD techique are a promising photoelectrode for PEC applications. Our data also indicate that CTR-VPTgrown nanorods produce uniform nanorod arrays, but this uniform nanostructure deposit does not lead to any increase in PEC activity.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.