This paper describes the design of a prosthetic hand for wrist amputations. The mechanism considers the use of three actuators: one each for the movement of the little finger, annular finger, and middle finger. The second actuator controls the index finger, and the third controls the thumb. The prototype is considered relevant as it is able to move the distal phalanx in all fingers; the little, annular, and middle fingers are able to adapt to the shape of the object being gripped (adaptive grip). The sequence of movements achieved with the thumb emulate the opposition/reposition and flexion/extension movements, commanded by a single actuator. The proposed design was built by additive manufacturing and effortlessly achieves a large number of grips. Additionally, the prosthesis could perform specific movements, such as holding a needle, although this grip demands higher precision in the control of the fingers. Due to the manufacturing method, the prosthesis weighs only 200 g, increasing to 450 g when the actuators are included, therefore weighing less than an average adult’s hand.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.