The design and characterization of a slow-wave series push-pull traveling wave silicon photonic modulator is presented. At 2 V and 4 V reverse bias, the measured -3 dB electro-optic bandwidth of the modulator with an active length of 4 mm are 38 GHz and 41 GHz, respectively. Open eye diagrams are observed up to bitrates of 60 Gbps without any form of signal processing, and up to 70 Gbps with passive signal processing to compensate for the test equipment. With the use of multi-level amplitude modulation formats and digital-signal-processing, the modulator is shown to operate below a hard-decision forward error-correction threshold of 3.8×10^-3 at bitrates up to 112 Gbps over 2 km of single mode optical fiber using PAM-4, and over 5 km of optical fiber with PAM-8. Energy consumed solely by the modulator is also estimated for different modulation cases.

No abstract

We present a silicon photonic traveling-wave Mach-Zehnder modulator operating near 1550 nm with a 3-dB bandwidth of 35 GHz. A detailed analysis of travelingwave electrode impedance, microwave loss, and phase velocity is presented. Small-and large-signal characterization of the device validates the design methodology. We further investigate the performance of the device in a short-reach transmission system. We report a successful 112-Gb/s transmission of four-level pulse amplitude modulation over 5 km of SMF using 2.2 V pÀp drive voltage. Digital signal processing is applied at the transmitter and receiver. 56-GBaud PAM-4 and 64-Gb/s PAM-2 transmission is demonstrated below a pre-FEC hard decision threshold of 4:4 Â 10 À3 .

We report on the design and characterization of focusing-curved subwavelength grating couplers for ultra-broadband silicon photonics optical interfaces. With implementation of waveguide dispersion engineered subwavelength structures, an ultra-wide 1-dB bandwidth of over 100 nm (largest reported to date) near 1550 nm is experimentally achieved for transverse-electric polarized light. By tapering the subwavelength structures, back reflection is effectively suppressed and grating coupling efficiency is increased to -4.7 dB. A compact device footprint of 40 µm × 20 µm is realized by curving the gratings in a focusing scheme.

We present an experimental study and analysis of a travelling wave series push-pull silicon photonic multi-electrode Mach-Zehnder modulator (ME-MZM) and compare its performance with a single-electrode travelling wave Mach-Zehnder modulator (TWMZM). Utilizing the functionality of the ME-MZM structure plus digital-signal-processing, we report: 1) the C-band transmission of 84 Gb/s OOK modulated data below the KP4 forward error correction threshold with 2 V drive voltage over a distance of 2 km; 2) the transmission of a 128 Gb/s optical 4-level pulse amplitude modulated signal over 1 km of fiber; and 3) the generation of a 168 Gb/s PAM-4 signal using two electrical OOK signals. By comparing the transmission system performance measurements for the ME-MZM with measurements performed using a similar series push-pull TWMZM, we show that the ME-MZM provides a clear advantage in achieving higher baud PAM-4 generation and transmission compared to a TWMZM.

No abstract

We present the detailed analysis and characterization of a silicon Michelson modulator with short 500 μm phase shifters and a low VπLπ of 0.72 V-cm under reverse bias. We investigate optical modulation of reverse biased p-n and forward biased p-i-n junctions. We demonstrate for the first time that error-free operation up to 40 Gbps is possible with lumped silicon interferometric modulators. For reverse bias operation, we show that even greater bandwidth can be obtained with lower impedance drivers. Forward bias operation with pre-emphasized signals is shown to have clean eye diagrams up to 40 Gbps, however, error counting reveals a strong dependence on test patterns and that error-free operation is achievable for short pattern lengths.

Abstract:We investigate a tapered, hybrid plasmonic waveguide which has previously been proposed as an optically efficient near-field transducer (NFT), or component thereof, in several devices which aim to exploit nanofocused light. We numerically analyze how light is transported through the waveguide and ultimately focused via effective-mode coupling and taper optimization. Crucial dimensional parameters in this optimization process are identified that are not only necessary to achieve maximum optical throughput, but also optimum thermal performance with specific application towards heat-assisted magnetic recording (HAMR). It is shown that existing devices constructed on similar waveguides may benefit from a heat spreader to avoid deformation of the plasmonic element which we achieve with no cost to the optical efficiency. For HAMR, our design is able to surpass many industry requirements in regard to both optical and thermal efficiency using pertinent figure of merits like 8.5% optical efficiency. 503-510 (2015). 15. C. Peng, "Efficient excitation of a monopole optical transducer for near-field recording," J. Appl. Phys. 112(4), 043108 (2012). 16. X. He, L. Yang, and T. Yang, "Optical nanofocusing by tapering coupled photonic-plasmonic waveguides," Opt.Express 19