No abstract

A molecularly imprinted polymer (MIP) based on free-radical polymerization was prepared with 1-(N,N-biscarboxymethyl)amino-3-allylglycerol and N,N-dimethylacrylamide as functional monomers, N,N-methylene diacrylamide as the cross-linker, copper ion-clonazepam as the template and 2,2-azobis(2-methylbutyronitrile) as the initiator. The imprinted polymer was characterized by Fourier transform infrared spectroscopy, elemental analysis, thermo-gravimetric analysis, and SEM. The MIP of agglomerated microparticles with multipores was used for SPE. The imprinted polymer sorbent was selective for clonazepam. The optimum pH and sorption capacity were 5 and 0.18 mg/g at 20C, respectively. The profile of the drug uptake by the sorbent reflects good accessibility of the active sites in the imprinted polymer sorbent. The MIP-SPE was the most feasible technique for the extraction of clonazepam with a high recovery from human plasma and urine samples.

The importance of piroxicam, a therapeutic anti-inflammatory drug, is well known. Because of gastrointestinal disorders, dermatological dosage forms are recommended most. In our first studies, oil-in-water (O/W) creams of piroxicam (1% concentration) were prepared using glyceryl monostearate (GMS), stearic acid, and triethanolamine as additive ingredients. In our second studies, hydroalcoholic transparent gel formulations of this drug in a 0.5% concentration were prepared using hydroxypropylcellulose (HPC) as the gelling agent. The release of piroxicam from all formulations via dialysis through a cellulose membrane into phosphate buffer pH 6.8 at 37 degrees C was studied. The effects of additives such as propylene glycol and 2-propanol on the drug release were also investigated. The release profiles from the standpoint of diffusion-controlled processes, as well as zero-order and first-order kinetics, were evaluated, and relevant parameters, such as diffusion coefficient, permeability coefficient, and partition coefficient, were calculated. The release obeys both the diffusion mechanism and first-order kinetics. The drug release from gel formulations containing 10%, 20%, and 30% propylene glycol was decreased due to the enhancement of viscosity. However, the limpidity of these formulations was improved. Moreover, the release of drug from gel formulations containing 15% and 20% of 2-propanol was increased. These results show that a hydroalcoholic gel formulation with HPC is a more suitable preparation of piroxicam when compared with an O/W cream formulation.

No abstract

The purpose of this study was to increase the solubility of glipizide (gli) by solid dispersions SDs technique with polyvinylpyrrolidone (PVP) in aqueous media. The gli-PVP solid dispersion systems was prepared by physical mixing or spray drying method, and characterized by differential scanning calorimetry (DSC), X-ray powder diffraction (XRD) analysis, Fourier transformation-infrared spectroscopy (FT-IR) and scanning electron microscopy (SEM). The elementary osmotic pumps (EOPs) were prepared with gli-PVP complex and the effect of the PVP percentages on the enhancing of gli dissolution rate was studied. The influences of various parameters e.g., drug- PVP ratio, level of solubility modifier, coating weight gain and diameter of drug releasing orifice on drug release profiles were also investigated. The solubility and dissolution rates of gli were significantly increased by solid dispersion using spray dried method as well as their physical mixture. The obtained results indicated that gli-PVP solid dispersion system has suitable solubility behavior in EOP tablets.