This paper critically investigates the advantages and limitations of the current-transient methods used for the study of the deep levels in GaN-based high-electron mobility transistors (HEMTs), by evaluating how the procedures adopted for measurement and data analysis can influence the results of the investigation. The article is divided in two parts within Part I. 1) We analyze how the choice of the measurement and analysis parameters (such as the voltage levels used to induce the trapping phenomena and monitor the current transients, the duration of the filling pulses, and the method used for the extrapolation of the time constants of the capture/emission processes) can influence the results of the drain current transient investigation and can provide information on the location of the trap levels responsible for current collapse. 2) We present a database of defects described in more than 60 papers on GaN technology, which can be used to extract information on the nature and origin of the trap levels responsible for current collapse in AlGaN/GaN HEMTs. Within Part II, we investigate how self-heating can modify the results of drain current transient measurements on the basis of combined experimental activity and device simulation

No abstract

Abstract-High-voltage Al 0 22 Ga 0 78 N-GaN high-electron mobility transistors have been fabricated using multiple field plates over dielectric passivation layers. The device breakdown voltage was found to increase with the addition of the field plates. With two field plates, the device showed a breakdown voltage as high as 900 V. This technique is easy to apply, based on the standard planar transistor fabrication, and especially attractive for the power switching applications.Index Terms-Breakdown voltage, field-effect transistors (FETs), field plates, high-electron mobility transistors (HEMTs), passivation, power electronics.

We describe the development of N-polar GaN-based high electron mobility transistors grown by N 2 plasma-assisted molecular beam epitaxy on C-face SiC substrates. High mobility AlGaN / GaN modulation-doped two-dimensional electron gas channels were grown, and transistors with excellent dc and small-signal performance were fabricated on these wafers. Large-signal dispersion was observed, and the trap states responsible for this were identified, and layer designs to remove the dispersive effects of these traps were demonstrated. Finally, an AlGaN-cap layer was used to reduce gate leakage in these devices, and a low-dispersion high breakdown voltage device was achieved. This detailed study of dispersion and leakage in N-polar GaN-based transistors establishes a technological base for further development of field effect devices based on N-polar III-nitrides.

Over the last decade, gallium nitride has emerged as an excellent material for the fabrication of power devices. Among the semiconductors for which power devices are already available on the market, GaN has the widest energy gap, the largest critical field, the highest saturation velocity, thus representing an excellent material for the fabrication of high speed/high voltage components.The presence of spontaneous and piezoelectric polarization allows to create a 2-dimensional electron gas, with high mobility and large channel density, in absence of any doping, thanks to the use of AlGaN/GaN heterostructures. This contributes to minimize resistive losses; at the same time, for GaN transistors switching losses are very low, thanks to the small parasitic capacitances and switching charges. Device scaling and monolithic integration enable high frequency operation, with consequent advantages in terms of miniaturization.For high power/high voltage operation, vertical device architectures are being proposed and investigated, and 3-dimensional structuresfin-shaped, trench-structured, nanowire-basedare demonstrating a great potential. Contrary to silicon, GaN is a relatively young material: trapping and degradation processes must be understood and described in detail, with the aim of optimizing device stability and reliability. This tutorial paper describes the physics, technology and reliability of GaN-based power devices: in the first part of the article, starting from a discussion of the main properties of the material, the characteristics of lateral and vertical GaN transistors are discussed in detail, to provide guidance in this complex and interesting field. The second part of the paper focuses on trapping and reliability aspects: the physical origin of traps in GaN, and the main degradation mechanisms are discussed in detail. The wide set of referenced papers and the insight on the most relevant aspects gives the reader a comprehensive overview on present and next-generation GaN electronics. IntroductionOver the past decade, gallium nitride has emerged as an excellent material for the fabrication of power semiconductor devices. Thanks to the unique properties of GaN, diodes and transistors based on this material have excellent performance, compared to their silicon counterparts, and are expected to find wide application in the next-generation power converters. Owing to the flexibility and the energy efficiency of GaN-based power converters, the interest towards this technology is rapidly growing: the aim of this tutorial is to review the most relevant physical properties, the operating principles, the fabrication parameters, and the stability/reliability issues of GaN-based power transistors. For introductory purposes, we start summarizing the physical reasons why GaN transistors achieve a much better performance than the corresponding silicon devices, to help the reader understanding the unique advantages of this technology.The properties of GaN devices allow the fabrication of high-efficiency (near or above 99 %)...

This paper reviews the progress of N-polar (000 1) GaN high frequency electronics that aims at addressing the device scaling challenges faced by GaN high electron mobility transistors (HEMTs) for radio-frequency and mixed-signal applications. Device quality (Al, In, Ga)N materials for N-polar heterostructures are developed using molecular beam epitaxy and metalorganic chemical vapor deposition. The principles of polarization engineering for designing N-polar HEMT structures will be outlined. The performance, scaling behavior and challenges of microwave power devices as well as highly-scaled depletion-and enhancement-mode devices employing advanced technologies including self-aligned processes, n+ (In,Ga)N ohmic contact regrowth and high aspect ratio T-gates will be discussed. Recent research results on integrating N-polar GaN with Si for prospective novel applications will also be summarized.

This paper describes a detailed analysis of the time-dependent degradation kinetics of GaN-based high electron mobility transistors submitted to reverse-bias stress. We show that: (1) exposure to reverse-bias may induce recoverable changes in gate leakage and threshold voltage, due to the accumulation of negative charge within the AlGaN layer, and of positive charge at the AlGaN/GaN interface. (2) Permanent degradation consists in the generation of parasitic leakage paths. Several findings support the hypothesis that permanent degradation is due to a defect percolation process: (2(a)) for sufficiently long stress times, degradation occurs even below the “critical voltage” estimated by step stress experiments; (2(b)) before permanent degradation, gate current becomes noisy, indicating an increase in defect concentration; and (2(c)) time to breakdown strongly depends on the initial defectiveness of the samples

This paper presents an extensive investigation of the properties of the trap with activation energy equal to 0.6 eV, which has been demonstrated to be responsible for current collapse (CC) in AlGaN/GaN HEMTs. The study was carried out on AlGaN/GaN HEMTs with increasing concentration of iron doping in the buffer. Based on pulsed characterization and drain current transient measurements, we demonstrate that for the samples under investigation: 1) increasing concentrations of Fe-doping in the buffer may induce a strong CC, which is related to the existence of a trap level located 0.63 eV below the conduction band energy and 2) this trap is physically located in the buffer layer, and is not related to the iron atoms but—more likely—to an intrinsic defect whose concentration depends on buffer doping. Moreover, we demonstrate that this level can be filled both under OFF-state conditions (by gate-leakage current) and under ON-state operation (when hot electrons can be injected to the buffer): for these reasons, it can significantly affect the switching properties of AlGaN/GaN HEMTs