This study evaluated the corrosion-fatigue life of laser-repaired specimens fabricated from commercially pure titanium (CP Ti) and Ti-6Al-4V alloy, tested under different storage conditions. For each metal, 30 dumbbell rods with a central 2.3 mm diameter were prepared by lost-wax casting with the Rematitan System. Simulating the failure after service, corrosion-fatigue life in different media at room temperature (air, synthetic saliva and fluoride synthetic saliva) was determined at a testing frequency of 10 Hz for intact specimens and after laser repairing, using a square waveform with equal maximum tensile and compressive stress that was 30% lower than the 0.2% offset yield strength. For laser welding, the fractured specimens were rejoined using a jig to align the sections invested in type-IV dental stone. The adjacent areas of the gap was air-abraded with 100 microm aluminum oxide, laser welded and retested under the same conditions as the initial intact specimens. The number of cycles at failure was recorded, and the fracture surface was examined with a scanning electron microscope (SEM). The number of cycles for failure of the welded and intact specimens was compared by anova and the Tukey test at a 5% probability level. Within the limitations of this study, the number of cycles required for fracture decreased in wet environments and the laser repairing process adversely affected the life of both metals under the corrosion-fatigue conditions.
Conventional spiral tomography plays an important role in pre-surgical treatment planning, increasing clinician's certainty of the need of additional surgical procedures (bone grafting, sinus lifting, and others) in pre-surgical treatment stage.
Considerando a importância da lisura superficial das restaurações provisórias, o objetivo desse trabalho foi de avaliar o efeito de diferentes métodos de acabamento e polimento sobre a rugosidade superficial de 05 resinas acrílicas autopolimerizáveis(Dencor®, Dencrilay®, Duralay®, Instatemp® e Vipi Cor®). Um total de 200 corpos de prova foram confeccionados, sendo 40 corpos de prova para cada resina, que foram obtidos a partir de uma matriz bipartida com ummolde cilíndrico de aço inoxidável de 10 mm de diâmetro e 3mm de profundidade. Cada material foi proporcionado de acordo com a recomendação de seu fabricante, inseridos no molde na fase plástica e após polimerização, todos osespécimes foram armazenados em umidificador à 37ºC por 24 horas. Dez espécimes de cada resina foram submetidos a cada um dos seguintes procedimentos: a) sof-lex + branco de espanha; b) sof-lex + selante de superfície; c) pedra-pomes+ branco de espanha; d) pedra-pomes + selante de superfície. Em seguida, a rugosidade superficial média (Ra medida em μm) foi aferida e registrada pelo rugosímetro (SJ-301, Mitutoyo – Japan) para posterior comparação entre os grupos.Os dados coletados foram submetidos à análise estatística através de testes paramétricos de “Kolmogorov-Smirnov” e análise de variância com nível de significância de 5%. Os resultados evidenciaram diferença estatisticamente significante em relação à rugosidade apenas entre a resina Instatemp® (menos rugosa) e a resina Vipi-Cor® (mais rugosa). No entanto, ao comparar os procedimentos de acabamento e polimento independente do tipo de resina acrílica, os dados evidenciaram diferenças numéricas, porém sem diferença estatisticamente significativa. Dentro das limitações desse estudo, concluiu-se que as resinas acrílicas apresentaram comportamento diferente em relação à rugosidade superficial média frente aos métodos de acabamento e polimento.
Background: Considering the limited qualitative and quantitative bone in the posterior arch, this modality of prosthetic treatment could provide a positive emotional factor reestablished by immovability of the anterior fixed implant-supported segment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.