No abstract

In this paper, silicon carbide fiber-reinforced silicon carbide (SiC f /SiC) composites were fabricated using binder jetting additive manufacturing followed by polymer infiltration and pyrolysis. Spherical SiC powders were produced using milling, spray drying, and thermal plasma treatment, and were characterized using SEM and XRD methods. Irregularly shaped and spherical SiC powders were used to obtain SiC f /SiC blends for the application in binder jetting. The effect of SiC powder shape on densification behavior, microstructure, and mechanical properties of binder jetted SiC f /SiC composites was evaluated. The highest density of 2.52 g/cm 3 was obtained after six polymer infiltration and pyrolysis cycles. The microstructure and mechanical properties of the fabricated SiC f /SiC composites were characterized. Using the spherical SiC powder resulted in higher fracture toughness and hardness, but lower flexural strength compared to the irregularly shaped powder. It was shown that it is feasible to fabricate dense SiC f /SiC composites using binder jetting followed by polymer infiltration and pyrolysis.

The authors deposited thin films of tin oxide on substrates of silicon and stainless steel by using atomic layer deposition (ALD) with tetraethyltin precursors. In this process, the authors used various coreactants such as water, oxygen, remote oxygen plasma, hydrogen peroxide, and ozone. The growth rates of films were studied as functions of the deposition temperature, the pulse times of the precursor and coreactant, and the number of ALD cycles, and the optimal growth conditions were determined. The film growth rates were found to be 0.025, 0.045, and 0.07 nm per cycle within the optimal growth conditions and ALD temperature windows for H2O2, O3, and O2 plasma, respectively. Using H2O or O2 did not prompt film growth. The films deposited using O3 and H2O2 had good continuity and low roughness, while the morphology of a coating prepared using oxygen plasma depended greatly on the deposition temperature. The films produced at temperatures below 300 °C were amorphous, irrespective of the coreactant used. X-ray photoelectron spectroscopy revealed that the samples mainly contained tin in the +4 oxidation state. The films deposited on stainless steel had high reversible capacity above 900 mA h g−1, exceptional cycleability, and good electrochemical performance as anodes for lithium-ion batteries.

No abstract

In this paper, laser powder-bed fusion (L-PBF) additive manufacturing (AM) with a high-temperature inductive platform preheating was used to fabricate intermetallic TiAl-alloy samples. The gas atomized (GA) and mechanically alloyed plasma spheroidized (MAPS) powders of the Ti-48Al-2Cr-2Nb (at. %) alloy were used as the feedstock material. The effects of L-PBF process parameters—platform preheating temperature—on the relative density, microstructure, phase composition, and mechanical properties of printed material were evaluated. Crack-free intermetallic samples with a high relative density of 99.9% were fabricated using 900 °C preheating temperature. Scanning electron microscopy and X-Ray diffraction analyses revealed a very fine microstructure consisting of lamellar α2/γ colonies, equiaxed γ grains, and retained β phase. Compressive tests showed superior properties of AM material as compared to the conventional TiAl-alloy. However, increased oxygen content was detected in MAPS powder compared to GA powder (~1.1 wt. % and ~0.1 wt. %, respectively), which resulted in lower compressive strength and strain, but higher microhardness compared to the samples produced from GA powder.

No abstract

No abstract

No abstract