No abstract

It has been found that the addition of certain components, despite their low concentration in raw mix, may accelerate and enhance the reactivity of the cement raw mix. The utilization of mineralizers to facilitate and quicken the process of clinkerization backpedals numerous years, the concept of using such mineralizers to burn normal raw mixes at a much lower temperature with the end goal of decreasing the fuel necessities of the furnace and to enhance the cement proprieties has become to be seriously considered over the most recent couple of years. The subject of this paper is to investigate the impact of calcium fluoride as mineralizer on addition during the clinkerization process of industrial raw mixtures and its effect on chemical, mineralogical, and mechanical properties of CPA Moroccan cement. Five different raw meals were utilized and were burned with 2% of calcium fluoride. The resulting clinker was analyzed by X-ray diffraction (XRD) and fluorescence spectroscopy to determine the chemical phases of the obtained clinker, and the mechanical properties of resulting CPA cement were determined. The results show that the addition of 2% of CaF 2 to the clinker raw meal induced a decrease in the burning temperature and free lime, while improving the clinker phase formation and the mechanical properties of obtained cement.

No abstract

The aim of this study is the synthesis and investigation of bioactive response of acrystalline silicophosphate.A monophasic silicocarnotite was elaborated by solid state reaction from a mixture of beta-tricaliciumphosphate and dicalcium silicate based on mussel shells according to the diagram of system Ca3(PO4)2–Ca2SiO4, at 65 % and 35% respectively , these starting materials are heated up to 1450 °C to obtain a monophasic silicocaronitite. The obtained result probed that the main crystalline phase which was detected and recognized in the heated sample at 1400 and 1450 °C was a well-crystallized silicocarnotite. The test of bioactivity of silicocarnotite in artificial saliva causes the appearance of a reaction layer on the materials surface after 4 hours soaking and growth up during 30 days.This layer is constituted of a biphasic mixture of Si–Ca–P–H material, silicated hydroxyapatite and hydroxyapatite phase are the mainly developing ones with increasing soaking time.The analysis and characterization of the precipitated appearing on the material surface has confirmed experimentally the in vitro bioactivity of silicocarnotite monophasic material.

In recent years, waste recycling has become a key issue in construction materials science for achieve the goal of sources of raw materials. The aim of this study is to use waste glass as source of SiO2 oxide and mussel shells consisting essentially of calcium carbonate as starting materials to synthesize belite rich cement. The elaborated clinker is chemically and structurally related to β-Ca2SiO4, by heat solid state activation. After grinding, the raw materials are mixed and heated up to 1050°C. The samples are characterized by X-ray diffraction (XRD) and Fourier Transformed Infrared spectroscopy (FT-IR). The mechanical strength of some sample was measured for 28 and 72 days. The results show the different mineralogical stapes of formation of clinker, the state reaction method allows the elaboration of a cementitious material by a simple heat treatment at relatively low temperature and low release of CO2. The hydration products are also identified by XR diffraction at 2, 7, 28 and 72 days.

Abstract. Solid waste generated during mining is one of the major environmental problems associated with this industrial activity. The best solution to overcome the environmental impact of this waste is to find recycling facilities in mass-produced products that can absorb the large quantities of these available byproducts. The present study shows the feasibility of using the coal waste of Moroccan Jerrada mining in the production of ecological brick. The first step consists of consecutive stages of crushing, grinding and heating at 650°C of the coal waste with a small amount of lime in order to promote the reactive products of elaborated binders. The second step of the process consists of mixing treated coal waste with a small amount of marble dust, sand, gravel, and water, then pressed and dried at room temperature to manufacture a laboratory ecofriendly bricks. The mechanical strength and thermal conductivity are investigated.

Solid waste generated during mining is one of the major environmental problems associated with this industrial activity. The best solution to overcome the environmental impact of this waste is to find recycling facilities in mass-produced products that can absorb the large quantities of these available byproducts. The present study shows the feasibility of using the coal waste of Moroccan Jerrada mining in the production of ecological brick. The first step consists of consecutive stages of crushing, grinding and heating at 650°C of the coal waste with a small amount of lime in order to promote the reactive products of elaborated binders. The second step of the process consists of mixing treated coal waste with a small amount of marble dust, sand, gravel, and water, then pressed and dried at room temperature to manufacture a laboratory ecofriendly bricks. The mechanical strength and thermal conductivity are investigated.

Calcium-silicate cement mainly based on dicalcium-silicate (C2S) was synthesized by the mean of solid state reaction. Beta-C3P was added to C2S to obtain C2S-C3P. Zinc oxide and bismuth oxide was incorporated to prepare radioc cement. In this work, the bioactivity and the mechanical strength of the synthesized cement were investigated. The in vitro test was carried out by immersion of cement pastilles in the artificial saliva in different periods from 4 hours to 30 days. Whereas the mechanical strength of some samples was operated at 28 and 72 days. The specimens are characterized by X-ray diffraction , Infrared spectroscopy and scanning electron microscopy. The finding results indicated that hydroxyapatite may appear after 24 hours of soaking; it was also shown that the presence of C3P with a small amount of the cement can enhance the bioactivity and develop more resistance strength of cement. Moreover, the addition of zinc oxide and bismuth oxide increase the radiopacity of the cement. However, the mechanical strength enhances with the incorporation of the zinc oxide while decrease with bismuth oxide. It was concluded then that there is possibility of combining addition of C3P (10%) and an agent radiopacifiers ZnO/Bi2O3(15%) with small amounts on C2S to obtain a cement with excellent bioactivity, good mechanical strength and significante radiopacity that makes this material a great candidate as a biomaterial for biomedical use.