We propose a bulk structured MXene, T i 3 A l C 2 deposited onto D-shaped fiber for soliton generation in an erbium-doped fiber laser (EDFL) cavity. Our saturable absorber (SA) device, based on MAX phase, was prepared by using stirring and ultrasonic vibration, which offer easier sample preparation compared with its 2D counterparts. By means of the polishing wheel technique, we fabricated a D-shaped fiber with a controlled polishing depth and incorporated the MAX phase T i 3 A l C 2 solution onto its polishing region. We obtained a mode-locked soliton pulse with the proposed MAX phase D-shaped (MAX-DS) SA in EDFL cavity. The pulse width, repetition rate, and central wavelength of the pulse train are 2.21 ps, 1.89 MHz, and 1557.63 nm, respectively. The polarization-insensitive EDFL cavity initiated a soliton operation with superior stability as the pump power tuned from 21 to 131 mW; further, the ML laser exhibits an average power of 15.3 mW, peak power of 3.8 kW, and pump efficiency of 12.5%. The MAX-DS SA incorporated inside the EDFL reveals efficient output performance, with a pulse energy of 8.14 nJ, the highest ever reported, to our best knowledge, among D-shaped fiber-based SA.

No abstract

No abstract

No abstract

Transparent conductive oxides (TCOs) are widely integrated in the field of optoelectronics since they are optically transparent and electrically conductive at the same time. Indium tin oxide (ITO) is a well-developed TCO, but due to its high cost, aluminum zinc oxide (AZO) is now emerging as a promising low-cost replacement for ITO. This work reports on AZO thin film prepared with polyvinyl alcohol (PVA) as a host material. The AZO–PVA thin film was incorporated into an erbium-doped fiber laser (EDFL) as a saturable absorber for the first time. Both Q-switched and nanosecond pulse mode-locked operation were experimentally achieved. The Q-switched EDFL operated at the center wavelength of 1559.6 nm, which had the shortest pulse width of 2.2 µs, the maximum repetition rate of 86 kHz and the highest pulse energy of 47.3 nJ. The mode-locked was achieved at the center wavelength of 1560.4 nm.

No abstract

A dark pulse mode-locked laser is experimentally demonstrated using the indium tin oxide (ITO) coated D-shape fiber as a saturable absorber (SA). Using the polishing wheel technique, a D-shape single mode fiber was fabricated. A 60-nm-thick layer of ITO was deposited over the D-shape fiber using the electron beam deposition method. The SA has a saturation intensity of 40.32 MW/cm2 and a modulation depth of 3.5%. A stable dark pulse mode-locked laser was observed at a central wavelength of 1559.4 nm with repetition rate 0.98 MHz, pulse width 370 ns and signal-to-noise ratio 61 dB.

No abstract