Vapor pressures and flash points for binary mixtures of tricyclo [5.2.1.02.6] decane and dimethyl carbonate

Xing, Yan; Shao, Dongbei; Fang, Wenjun; Guo, Yihang; Lin, Ruisen

doi:10.1016/j.fluid.2009.06.002

Cited by 9 publications

(9 citation statements)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…1/2 (6) where N is the number of experimental datum points and n is the order of the polynomial, Y expt,i is the calculated value from the experimental measurement, and Y calc,i is the value obtained from eq 5.…”

Section: Resultsmentioning

confidence: 99%

“…The high density hydrocarbon fuels with high carbon− hydrogen ratio, however, may lead to combustion problems such as soot, spray, and strong flame radiation. 6,7 Alcohols as additives are used in some hydrocarbon fuels to improve the ignition and combustion characteristics to a certain extent. 8,9 In addition, long-chain or cyclic alcohols have relatively high densities, and the densities of the mixtures will not be decreased when a small amount of the alcohols are added into hydrocarbons.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Density, Viscosity, Refractive Index, and Surface Tension for Six Binary Systems of Adamantane Derivatives with 1-Heptanol and Cyclohexylmethanol

Cao

Qin

et al. 2014

J. Chem. Eng. Data

Self Cite

View full text Add to dashboard Cite

Measurements on densities (ρ), viscosities (η), and refractive indices (n D ) from (293.15 to 333.15) K and at 0.1 MPa along with the surface tensions (γ) at 298.15 K and 0.1 MPa for binary mixtures of 1,3-dimethyladamantane (1,3-DMA), 1-ethyladamantane (1-EA), and 1,3,5-trimethyladamantane (1,3,5-TMA) with 1-heptanol or cyclohexylmethanol have been carried out over the entire composition range. The experimental data are used to calculate the excess molar volumes (V m E ), viscosity deviations (Δη), molar refraction deviations (Δ Φ R), and surface tension deviations (Δγ). The V m E , Δη, Δ Φ R, and Δγ values have been fitted to the Redlich−Kister polynomial equation. From these excess or deviation functions, the molecular interactions and nonideality of the binary systems are discussed. The results are expected to provide fundamental data for understanding the properties of adamantane derivatives as potential components and the composition optimization of new high energy-density hydrocarbon fuels.

show abstract

Section: Resultsmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Density, Viscosity, Refractive Index, and Surface Tension for Six Binary Systems of Adamantane Derivatives with 1-Heptanol and Cyclohexylmethanol

Cao

Qin

et al. 2014

J. Chem. Eng. Data

Self Cite

View full text Add to dashboard Cite

show abstract

“…It is a candidate fuel for supersonic aircraft and hypersonic missile. A large amount work have been put into investigating the thermophysical properties of JP-10 including density, viscosity, heat capacity, vapor pressure, and speed of sound, etc. − as well as its thermal and chemical stability − which is necessary for its application.…”

Section: Introductionmentioning

confidence: 99%

Measurement and Correlation of the Solubilities of Oxygen, Nitrogen, and Carbon Dioxide in JP-10

Liu

Bai

et al. 2017

J. Chem. Eng. Data

View full text Add to dashboard Cite

New experimental solubility data of nitrogen, oxygen, and carbon dioxide in JP-10 (exotetrahydrodicyclopentadiene) in the temperature range from 293 to 343 K in the intervals of 10 K and in the pressure range from 0.5 to 7.5 MPa were reported. The relative expanded uncertainty of solubility measurement is estimated to be less than 4% with a level of confidence of 95%. The solubility order of the three gases in JP-10 in the studied temperature and pressure range is carbon dioxide > oxygen > nitrogen. The Henry’s constants and the thermodynamic properties of solvation were calculated from the solubility data. A modified KK equation was used to represent the experimental data with AARD less than 1.9%.

show abstract

“…A literature review reveals that Liaw et al's model is the most frequently used [19,[30][31][32][33][34]. In this paper, we intend to apply it to systematically investigate the flash-point of binary and ternary miscible mixtures either of flammable solvents or of aqueous−organic mixtures, some with new experimental data published here for the first time.…”

Section: Introductionmentioning

confidence: 99%

Prediction of miscible mixtures flash-point from UNIFAC group contribution methods

Liaw¹,

Gerbaud²,

Li³

2011

Fluid Phase Equilibria

View full text Add to dashboard Cite

Vapor pressures and flash points for binary mixtures of tricyclo [5.2.1.02.6] decane and dimethyl carbonate

Cited by 9 publications

References 15 publications

Density, Viscosity, Refractive Index, and Surface Tension for Six Binary Systems of Adamantane Derivatives with 1-Heptanol and Cyclohexylmethanol

Density, Viscosity, Refractive Index, and Surface Tension for Six Binary Systems of Adamantane Derivatives with 1-Heptanol and Cyclohexylmethanol

Measurement and Correlation of the Solubilities of Oxygen, Nitrogen, and Carbon Dioxide in JP-10

Prediction of miscible mixtures flash-point from UNIFAC group contribution methods

Contact Info

Product

Resources

About