Utility of virtual monoenergetic images from spectral detector computed tomography in improving image segmentation for purposes of 3D printing and modeling

Abstract

Background One of the key steps in generating three-dimensional (3D) printed models in medicine is segmentation of radiologic imaging. The software tools used for segmentation may be automated, semi-automated, or manual which rely on differences in material density, attenuation characteristics, and/or advanced software algorithms. Spectral Detector Computed Tomography (SDCT) is a form of dual energy computed tomography that works at the detector level to generate virtual monoenergetic images (VMI) at different energies/ kilo-electron volts (keV). These VMI have varying contrast and attenuation characteristics relative to material density. The purpose of this pilot project is to explore the use of VMI in segmentation for medical 3D printing in four separate clinical scenarios. Cases were retrospectively selected based on varying complexity, value of spectral data, and across multiple clinical disciplines (Vascular, Cardiology, Oncology, and Orthopedic). Results In all four clinical cases presented, the segmentation process was qualitatively reported as easier, faster, and increased the operator’s confidence in obtaining accurate anatomy. All cases demonstrated a significant difference in the calculated Hounsfield Units between conventional and VMI data at the level of targeted segmentation anatomy. Two cases would not have been feasible for segmentation and 3D printing using conventional images only. VMI data significantly reduced conventional CT artifacts in one of the cases. Conclusion Utilization of VMI from SDCT can improve and assist the segmentation of target anatomy for medical 3D printing by enhancing material contrast and decreasing CT artifact. Electronic supplementary material The online version of this article (10.1186/s41205-019-0038-y) contains supplementary material, which is available to authorized users.

Dual energy imaging in cardiothoracic pathologies: A primer for radiologists and clinicians

“…3). Medical 3D printing commonly uses CT as the source for anatomic segmentation and using DECT images improves the medical 3D printing workflow over conventional CT [ 72 ]. Additionally, the combination of contrast enhancing properties from low keV VMI and artifact reduction from high keV VMI improves the ability of automated segmentation tools to threshold and differentiate critical anatomic structures for 3D printing (Supplemental Fig.…”

DICOM segmentation and STL creation for 3D printing: a process and software package comparison for osseous anatomy

“…Three-dimensional (3D) printing from DICOM images has become easier with the advancement of technologies such as medical engineering, imaging engineering, and the evolution and decreasing costs of hardware and software. Patient-specific 3D models are now being used in many situations within the oral and maxillofacial surgery fields, including education, surgical planning, and surgical simulation [ 1 – 4 ].…”

DICOM segmentation and STL creation for 3D Printing: A Process and Software Package Comparison for Osseous Anatomy

“…Three-dimensional (3D) printing from DICOM images has become easier with the advancement of technologies such as medical engineering, imaging engineering, and the evolution and decreasing costs of hardware and software. Patient-speci c 3D models are now being used in many situations within the oral and maxillofacial surgery elds, including education, surgical planning, and surgical simulation [1][2][3][4].…”