Using deep eutectic solvents to electrodeposit CoSm films and nanowires

Cojocaru, Paula; Magagnin, Luca; Gómez, Elvira; Vallés, E.

doi:10.1016/j.matlet.2011.08.003

Cited by 64 publications

(47 citation statements)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In fact, there have been some reports on magnetic films such as Ni, Co, Ni-Co, Ni-Co-Sn, Sm-Co, and Co-Pt prepared from DESbased baths, [3][4][5][6][7][8][9][10] and we have also reported Fe and Fe-Ni films prepared in DES-based plating baths. 11,12 In our previous studies, we confirmed that the plating processes from the DES-based baths for the Fe and the Fe-Ni films have high current efficiency (>90%).…”

Section: Introductionmentioning

confidence: 62%

Magnetic Fe-Co films electroplated in a deep-eutectic-solvent-based plating bath

Yanai

Shiraishi

Watanabe

et al. 2015

Journal of Applied Physics

View full text Add to dashboard Cite

We fabricated Fe-Co films from a deep eutectic solvent (DES)-based plating bath and investigated magnetic properties of the plated films. The plating baths were obtained by stirring the mixture of choline chloride, ethylene glycol, FeCl 2 Á4H 2 O, and CoCl 2 Á6H 2 O. The composition of the plated films depended on the amount of FeCl 2 Á4H 2 O in the plating bath, and Fe content of the films was varied from 0 to 100 at. %. Depending on the Fe content, the saturation magnetization and the coercivity of the films varied. The Fe 76 Co 24 film shows high saturation magnetization and smooth surface, and the change in the saturation magnetization shows good agreement with the expected change by the Slater-Pauling curve. High current efficiency (>90%) could be obtained in the wide film composition. From these results, we concluded that the DES-based plating bath is one of effective baths for the Fe-Co films with high current efficiency. V C 2015 AIP Publishing LLC.

show abstract

Section: Introductionmentioning

confidence: 62%

Magnetic Fe-Co films electroplated in a deep-eutectic-solvent-based plating bath

Yanai

Shiraishi

Watanabe

et al. 2015

Journal of Applied Physics

View full text Add to dashboard Cite

show abstract

“…[13][14][15] On the other hand, SmCo film grown in a 1ChCl:2EG solution without glycine presents a significantly higher coercive field H c = 270 Oe (21.5 A/m), in agreement with the value reported for the 1ChCl:2U system. [4][5][6] The out-of-plane direction is again a hard axis for the magnetization (Figure 6b). A comparison between the in-plane M(H) curves for the three samples is shown in Figure 7.…”

Section: Resultsmentioning

confidence: 93%

“…On the other hand, by increasing further the deposition potential (−0.9/−0.95 V vs Ag wire), the formation of oxide/hydroxide powders on the cathodic surface was observed. 4,5 Moreover, the employment of ethylene glycol instead of urea lowers significantly the viscosity thus increasing the conductivity. Both choline chloride concentration and glycine affect significantly film composition.…”

Section: Resultsmentioning

confidence: 99%

Electrodeposition of Magnetic SmCo Films from Deep Eutectic Solvents and Choline Chloride-Ethylene Glycol Mixtures

Panzeri

Tresoldi

Rinaldi

et al. 2017

J. Electrochem. Soc.

View full text Add to dashboard Cite

Suitability of mixtures based on ethylene glycol and choline chloride is evaluated for the electrodeposition of magnetic SmCo alloys. Deep eutectic solvents (DES) are characterized by a wide electrochemical window, allowing the electrodeposition of metallic elements having a highly negative reduction potential. Electrodeposition of unconventional metals with reduction potential well below hydrogen evolution one is, in principle, feasible (e.g. Sm). Moreover, the limited presence of water during the growth of SmCo alloys may reduce oxidation and consequently improve the magnetic properties with respect to the employment of an aqueous bath. Deposits composition is strongly affected by process parameters and bath composition. Increasing choline chloride concentration and/or adding glycine to the solution allows to achieve higher Sm content in the deposit. Potentiostatic electrodeposition has been carried out in a conventional three electrodes cell, with potential interval selected from −0. The role of non-aqueous electrolytes is gaining importance due to their ability to overcome limitations normally observed in the electrodeposition processes from aqueous media. In particular, this is true for the metal elements having reduction potential well below hydrogen evolution one. Ionic liquids are in fact characterized by wider electrochemical windows limiting the onset of secondary processes suppressing the metal reduction one.1-3 One practical example is the electrodeposition of rare earth metals and their alloys (e.g. SmCo). Gomez et al. and Cojocaru et al. proposed a study on the electrodeposition of SmCo from a deep eutectic solvent (DES) based on choline chloride and urea (1ChCl:2U). [4][5][6] The suitability of such a system for the electrodeposition of both single metals (Sm and Co) and alloy (SmCo) was verified. Deposits were characterized by a high Sm content, i.e. 46-79 wt% Sm, while the optimal composition for the best magnetic performances is 23-25 wt% Sm, corresponding to the Sm 2 Co 17 phase. [7][8][9] In literature, works on this alloy from both waterbased 10-16 and non-aqueous solution are reported. 17 In the former case, fundamental is the employment of glycine as complexing agent as shown by Wei et al. [13][14][15] However, in-plane coercivities in the order of H c|| = 100 Oe were observed with the formation of SmO, Sm(OH) 3 and Co(OH) 2 .14 These values are referred to films produced by electrodeposition, an interesting technique from the fabrication point of view but with a huge limitations in terms of compositional and purity control with respect to traditional methods as casting or sputtering through which hard SmCo magnets are obtained (H c|| ∼ kOe).This work consists in the study of different mixtures based on ethylene glycol and choline chloride (1ChCl:2EG and 1ChCl:4.5EG) in order to evaluate the effect of ChCl concentration on SmCo codeposition and its magnetic properties. Studies on the physical properties of solutions with different ChCl:HBD (Hydrogen Bond Donor) molar ratio are reported in ...

show abstract

“…3 Table 14 shows the conductivities observed in DESs which are comparable to ionic liquids; 44,45 DESs are therefore a highly investigated medium for electrochemical applications. [46][47][48][49][50][51][52][53][54][55][56][57][58][59][60][61][62][63] Readers interested in electrodeposition from ILs and DESs will find a good review in ref. 64.…”

Section: Molar Heat Capacities and Conductivitymentioning

confidence: 99%