Tunable colors and conductivity by electroless growth of Cu/Cu2O particles on sol-gel modified cellulose

Abstract

Development of colored surfaces by formation of nano-structured aggregates is a widely used strategy in nature to color lightweight structures (e.g. butterflies) without the use of dye pigments. The deposition of nanoscale particles mimics nature in it's approach coloring surfaces. This work presents sol-gel modification of cellulose surfaces used to form a template for growth of Cu/Cu 2 O core-shell particles with defined size-distributions. Besides improving the adhesion of the deposited particulate material, the sol-gel matrix serves as a template for the control of particle sizes of the Cu/Cu 2 O structures, and as a consequence of particle size variation the surface color is tunable. As an example, red color was achieved with an average particle size of 35 nm, and shifts gradually to blue appearance when particles have grown to 80 nm on the sol-gel modified fabric. The copper concentration on representative fabrics is kept low to avoid modifying the textile characteristics and were all in the range of 150-170 mg per g of cellulose material. As a result of copper deposition on the surface of the material, the cellulose fabric also became electrically conductive. Remarkably, the electrical conductivity was found to be dependent on the average particle sizes of the deposits and thus related to the change in observed color. The generation of color by growth of nano-sized particles on sol-gel templates provides a highly promising approach to stain surfaces by physical effects without use of synthetic colorants, which opens a new strategy to improve environmental profile of coloration.

Structural Colored Fabrics with Brilliant Colors, Low Angle Dependence, and High Color Fastness Based on the Mie Scattering of Cu2O Spheres

“…Recently, some approaches have been applied to color fabrics with structural color materials. − Among them, the most commonly applied method is forming a close-packed photonic crystal (PC) − structure or an amorphous photonic structure (APS) − on the surface of fabrics using polystyrene (PS), SiO 2 , and other low-refractive-index spheres ( n < 1.6) as a building block. Large-area structural colored fabrics were prepared by assembling PS spheres into ordered PCs on the surface of fabrics .…”

A Programmable Dual‐Regime Spray for Large‐Scale and Custom‐Designed Electronic Textiles

“…The mass load increased as P A increased to reach the maximum (≈18 mg cm −2 ) at D S = 2 mm, which is substantially higher than those reported in previous studies. [ 24,25 ] The penetration depth also increased as P A increased where the deep penetration (>600 µm) into fabrics occurred with P A ≥ 70 kPa at D S = 2 mm. The high mass load and deep penetration resulted in sufficiently low electrical resistance (<2.6 Ω) at the optimal condition.…”

Multi-Point Flexible Temperature Sensor Array and Thermoelectric Generator Made from Copper-Coated Textiles

“…In this case, a power output of 5.5·10 −11 Watt can be realized at the consumer. An optimization of the assembly with an increased number of junctions, an optimized geometry and the use of copper-coated textiles that show even lower electrical resistivity [ 20 ], will directly lead to a higher energy output. This becomes clear when comparing the textile-foil-based assembly with the foil-based assembly, which offers a current flow of 385 nA and a power output of 14.7·10 −11 Watt.…”