The use of petroleum coke as fuel in a 10kWth chemical-looping combustor

Berguerand, Nicolas; Lyngfelt, Anders

doi:10.1016/j.ijggc.2007.12.004

Cited by 207 publications

(165 citation statements)

References 19 publications

Supporting

Mentioning

163

Contrasting

Order By: Relevance

“…In previous CLC experiments with solid fuels performed to date, full oxidation of the outlet fuel reactor stream could not be achieved [8][9][10][11][12][13][14][15][16][17]. Furthermore, the extent of unburt gases was similar as if a highly Ni-based oxygen carrier was used [14][15][16].…”

Section: Solid Fuelmentioning

confidence: 98%

“…Ilmenite was found to be an appropriate material for its use as oxygen carrier in CLC with solid fuels [8][9][10][11]. Ilmenite is a relatively cheap and abundantly occurring mineral mainly consisting of FeTiO 3 .…”

Section: Solid Fuelmentioning

confidence: 99%

“…Furthermore, the extent of unburt gases was similar as if a highly Ni-based oxygen carrier was used [14][15][16]. Therefore, in order to oxidize completely unburnt compounds to CO 2 and H 2 O and enhance combustion, an oxygen polishing step downstream was proposed, that is, injection of pure oxygen to the gas flow after the fuel reactor cyclone [8,9], with the corresponding oxygen demand.…”

Section: Solid Fuelmentioning

confidence: 99%

“…As for continuous operation, Berguerand and Lyngfelt [8][9][10][11] used a 10 kW th chemicallooping combustor with ilmenite as oxygen carrier and South African coal and petroleum coke as solid fuels. They analyzed the combustion process focusing on char conversion and the conversion of gases from steam gasification (CO and H 2 ) was analyzed.…”

Section: Solid Fuelmentioning

confidence: 99%

“…The most used for solid fuel combustion is the two interconnected fluidized beds configuration [8][9][10][11][12][13][14][15][16][17], for which the two reactors are the fuel and the air reactor. In the fuel reactor the oxygen carrier is reduced through oxidation of the fuel, thus obtaining a gas stream composed of CO 2 and H 2 O.…”

Section: Introductionmentioning

confidence: 99%

See 4 more Smart Citations

Relevance of the coal rank on the performance of the in situ gasification chemical-looping combustion

Cuadrat

Abad

Gayán

et al. 2012

Chemical Engineering Journal

100

View full text Add to dashboard Cite

In this work the CLC process for solid fuels using ilmenite as oxygen carrier was evaluated in a continuous CLC unit. In this process, gasification of solid fuel happens in the fuel reactor which is fluidized by a gasifying agent, i.e, H 2 O. This process has been referred as in-situ Gasification CLC, iG-CLC. The feasibility of using fuels ranging from lignite to anthracite and the effect of the coal rank on the process performance was evaluated. The carbon capture efficiency followed the trend of the coal rank, as it was higher for lignite, then for the bituminous coals and it was lower for anthracite. Special attention was put on the combustion of the volatile matter of the different fuels. In all cases oxygen demands lower than 10% were found; for anthracite the oxygen demand values were 3.5% because of the lower volatile content of this fuel. A temperature increase was proven to be advantageous to reach high carbon capture and combustion efficiencies for all the fuels tested. Also, the feasibility of using H 2 O:CO 2 mixtures as gasification agent with each type of fuel was also assessed and it was seen that in case of bituminous coals and lignite some of H 2 O can be replaced by CO 2 .

show abstract