Synthesis and mechanical properties of para‐aramid nanofibers

Abstract

Scalable, bottom‐up chemical synthesis and electrospinning of novel Cl‐substituted poly(para‐phenylene terephthalamide) (PPTA) nanofibers are herein reported. To achieve Cl‐PPTA nanofibers, the chemical reaction between the monomers was precisely controlled, and dissolution of the polymer into solvent was tailored to enable anisotropic solution formation and sufficient entanglement molecular weight. Electrospinning processing parameters were studied to understand their effects on fiber formation and mat morphology and then optimized to yield consistently high quality fibers. Importantly, the control of relative humidity during the fiber formation process was found to be critical, likely because water promotes hydrogen bond formation between the PPTA chains. The fiber and mat morphologies resulting from different combinations of chemistry and spinning conditions were observed using scanning electron microscopy, and observations were used as inputs to the optimization process. Tensile properties of single Cl‐PPTA nanofibers were characterized for the first time using a nanomanipulator mounted inside a scanning electron microscope (SEM), and fiber moduli measuring up to 70 GPa, and strengths exceeding 1 GPa were achieved. Given the excellent mechanical properties measured for the nanofibers, this chemical synthesis procedure and electrospinning protocol appear to be a promising route for producing a new class of nanofibers with ultrahigh strength and stiffness. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019, 57, 563–573

A Review on the Impact of Humidity during Electrospinning: From the Nanofiber Structure Engineering to the Applications

“…As it was shown in the previous chapters, ambient humidity must be controlled during electrospinning in order to tune the structure of the fibrous membranes in all length scales. In a processing point of view, the control of RH is important in terms of processability [ 157 ] and the properties reproducibility of the fabricated materials. [ 35 ] Obviously, as humidity has an impact on the fiber and mat morphologies, the physical properties are thus also linked with the RH imposed during electrospinning.…”

Hydrogel tapes for fault-tolerant strong wet adhesion

“…Eventually, dopaquinone forms covalent linkages with primary amine and thiol groups slowly (in hours) to render strong adhesion 43 – 46 . This timescale-dependent adhesion is precisely regulated by the pH of the environment and the presence of enzymes 47 . Remarkably, through this complicated dopa chemistry, mussels can integrate simultaneous strong and instant adhesion with a fail-safe timing mechanism to prevent premature solidification in the secretory system or mistargeted adhesion.…”

High‐performance tetraphenylethene‐containing poly (p‐phenylene terephthalamide) paper with aggregation‐induced emission characteristics

“…It is considered a promising candidate for hightemperature-resistant insulating materials in intelligent equipment for the fifth-generation (5G) era. [7][8][9][10][11] Fluorescent ANF and ANF paper are gaining increasing importance for an array of applications, such as smart textiles with functional features, although they remain relatively rare.…”