Permanent-Magnet Machine-Based Starter–Generator System With Modulated Model Predictive Control

Yeoh, Seang Shen; Yang, Tao; Tarisciotti, Luca; Hill, Christopher Ian; Bozhko, Serhiy; Zanchetta, Pericle

doi:10.1109/tte.2017.2731626

Cited by 59 publications

(30 citation statements)

References 25 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…AC to DC power conversion is needed in applications such as connecting an AC generator to a DC electrical system [41] as well as front end power converters for back-to-back AC to AC power converters. Traditionally passive rectifiers using diodes have dominated [42] these applications.…”

Section: Ac To DC Power Convertersmentioning

confidence: 99%

“…By turning round the standard inverter circuit and ensuring that there is sufficient inductance on the AC side of the converter it is possible to produce good quality AC current waveforms with just some switching frequency components in the AC current waveforms [42]. If additional power quality is required then an NPC converter can be used in a similar approach as for the DC to AC power converters [41].…”

Section: Ac To DC Power Convertersmentioning

confidence: 99%

“…Matrix converters could be used without the ATRU to provide the same service.  For the starter/generators, three-phase full-bridge are adopted, although multilevel topologies have been demonstrated in literature [41].  The low-voltage electronics is supplied by TRU, although DAB or other high-frequency DC/DC converters [57] could be adopted for the same purpose.…”

Section: Power Electronics and Electrical Subsystem Mappingmentioning

confidence: 99%

“…Control targets are voltage and frequency stability as well as the optimal use of the storage. The primary controls are embedded in the loads and include the torque/force control for the actuators [58], the control of the rectifier for the electrical generators: synchronous [62], [63], induction [64], permanent magnet [41], [65]. Both standard regulators and more advanced approaches, like predictive control [66] have been proposed.…”

Section: Control Aspectsmentioning

confidence: 99%

See 3 more Smart Citations

On-Board Microgrids for the More Electric Aircraft—Technology Review

Buticchi

Bozhko

Liserre

et al. 2019

IEEE Trans. Ind. Electron.

Self Cite

185

View full text Add to dashboard Cite

This paper presents an overview of technology related to on-board microgrids for the More Electric Aircraft. All aircraft use an isolated system, where security of supply and power density represent the main requirements. Different distribution systems (AC and DC) and voltage levels coexist, and power converters have the central role in connecting them with high reliability and high power density. Ensuring the safety of supply with a limited redundancy is one of the targets of the system design, since it allows increasing the power density. This main challenge is often tackled with proper load management and advanced control strategies, as highlighted in this paper.

show abstract

Section: Ac To DC Power Convertersmentioning

confidence: 99%

Section: Ac To DC Power Convertersmentioning

confidence: 99%

Section: Power Electronics and Electrical Subsystem Mappingmentioning

confidence: 99%

Section: Control Aspectsmentioning

confidence: 99%

See 2 more Smart Citations

On-Board Microgrids for the More Electric Aircraft—Technology Review

Buticchi

Bozhko

Liserre

et al. 2019

IEEE Trans. Ind. Electron.

Self Cite

185

View full text Add to dashboard Cite

show abstract

“…Vector control approach is selected over direct torque control(DTC) for the PMSM as DTC lack of direct current regulation, which is required in the control of power flowing between the engine shaft and aircraft DC-bus. Modulated model predictive control is also developed for the project as a parallel option [24], and has been achieved on a two-level converter based drive. However, model predictive control techniques have poor tolerance against parameter variations, whereas the ESG sometimes operates at a temperature as low as -70 ℃, which leads to significant parameter variation.…”

Section: A Esg System Characteristics and Controlmentioning

confidence: 99%

A Modified Neutral Point Balancing Space Vector Modulation for Three-Level Neutral Point Clamped Converters in High-Speed Drives

Yang

Kulsangcharoen

et al. 2019

IEEE Trans. Ind. Electron.

Self Cite

View full text Add to dashboard Cite

Pareto-based modulated model predictive control strategy for power converter applications

Santis

Sáez

Cárdenas

et al. 2019

Electric Power Systems Research

View full text Add to dashboard Cite

Modulated model predictive control (M 2 PC) allows fixed switching frequency operation of power converters, producing lower ripple and lower total harmonic distortion (THD) in the output signals than those obtained using regular model predictive control (MPC) algorithms. However, the design of the M 2 PC algorithm and its performance depend on, among other factors, the tuning of weighting factors, which are required by the cost functions typically used in predictive control algorithms. In this paper, a novel Pareto-based multi-objective M 2 PC (MO-M 2 PC) strategy is proposed. In this case, the use of weighting factors is not required, and the optimization problem is solved using a multi-objective approach. The aim of the proposed MOM 2 PC strategy is to consider practical rules, such as satisfaction of soft constraints, to calculate the control actions. The proposed Pareto-based MOM 2 PC strategy can be applied to any power converter topology. In this paper, experimental validation of the proposed methodology is pursued using a 3-phase 3 kW power converter operating as a shunt active power filter (SAPF). The proposed control is implemented in a control platform based on the dSPACE ds1103 system. The simulation and experimental results demonstrate the advantages and flexibility achieved by the proposed Pareto-based MOM 2 PC.

show abstract

Permanent-Magnet Machine-Based Starter–Generator System With Modulated Model Predictive Control

Cited by 59 publications

References 25 publications

On-Board Microgrids for the More Electric Aircraft—Technology Review

On-Board Microgrids for the More Electric Aircraft—Technology Review

A Modified Neutral Point Balancing Space Vector Modulation for Three-Level Neutral Point Clamped Converters in High-Speed Drives

Pareto-based modulated model predictive control strategy for power converter applications

Contact Info

Product

Resources

About