Kinetic modeling of nicotine in mainstream cigarette smoking

Abstract

BackgroundThe attempt to understand the kinetic behavior of nicotine in tobacco will provide a basis for unraveling its energetics in tobacco burning and the formation of free radicals considered harmful to the cigarette smoking community. To the best of our knowledge, the high temperature destruction kinetic characteristics of nicotine have not been investigated before; hence this study is necessary especially at a time addiction science and tobacco research in general is gaining intense attention.MethodsThe pyrolysis of tobacco under conditions simulating cigarette smoking in the temperature region 200–700 °C has been investigated for the evolution of nicotine and pyridine from two commercial cigarettes coded ES1 and SM1 using gas chromatography hyphenated to a mass selective detector (MSD). Moreover, a kinetic model on the thermal destruction of nicotine within a temperature window of 673 and 973 K is proposed using pseudo-first order reaction kinetics. A reaction time of 2.0 s was employed in line with the average puff time in cigarette smoking. Nonetheless, various reaction times were considered for the formation kinetics of nicotine.ResultsGC–MS results showed the amount of nicotine evolved decreased with increase in the puff time. This observation was remarkably consistent with UV–Vis data reported in this investigation. Generally, the temperature dependent rate constants for the destruction of nicotine were found to be s−1 and s−1 for ES1 and SM1 cigarettes respectively. In addition, the amount of nicotine evolved by ES1 cigarette was ~10 times more than the amount of nicotine released by SM1 cigarette.ConclusionThe suggested mechanistic model for the formation of pyridine from the thermal degradation of nicotine in tobacco has been found to be agreement with the kinetic model proposed in this investigation. Consequently, the concentration of radical intermediates of tobacco smoke such as pyridinyl radical can be determined indirectly from a set of integrated rate laws. This study has also shown that different cigarettes can yield varying amounts of nicotine and pyridine depending on the type of cigarette primarily because of potential different growing conditions and additives introduced during tobacco processing. The activation energy of nicotine articulated in this work is consistent with that reported in literature.Graphical abstractThe anatomy of tobacco cigarette and the major chemistry involved during combustion (pyrolysis, GC–MS analysis, and kinetic modeling) Electronic supplementary materialThe online version of this article (doi:10.1186/s13065-016-0206-8) contains supplementary material, which is available to authorized users.

Dioxin and dibenzofuran like molecular analogues from the pyrolysis of biomass materials—the emerging challenge in bio-oil production

“…The concentration of oxygen in the oxidative pyrolysis experiments was kept low to optimize the formation of molecular products. Generally, fractional pyrolysis is applied as an experimental technique in which the same sample is continuously pyrolyzed at each pyrolysis temperature [19]. This is a selective in situ conversion of biopolymers to molecular products [6].…”

Optimization of Binary Mixtures of Biodiesel and Fossil Diesel for Clean Energy Combustion

“…In order to investigate the nature of molecular products for optimization for clean energy combustion, different binary mixtures in the ratio of 1:1, 3:2 and 2:3 volume were separately introduced into a pyrolysis reactor. Croton megalocarpus biodiesel and fossil diesel were mixed and placed in a quartz reactor of volume 7.56 cm 3 housed in a furnace (Thermo-Scientific Inc., USA) [21,35]. Pyrolysis was conducted at an optimum temperature of 500 °C under a flow of nitrogen at a residence time of 5 s at 1 atmosphere, as model pyrolysis conditions in the reactor ideally representative of the conditions inside a combustion engine.…”

“…1 The reactor assembly [21] siloxane (30 m × 250 µm × 0.25 µm). The port injector temperature was set at 250 °C to vaporize organic components to be amenable for GCMS analysis [35]. The carrier gas was ultra-high pure (UHP) helium (99.999%) and the flow rate was 3.3 mL min −1 .…”

Surface bound radicals, char yield and particulate size from the burning of tobacco cigarette

“…Formation of smoke from a burning cigarette depends on a series of mechanisms, including generation of products by pyrolysis and combustion, aerosol formation, and physical mass transfer processes [ 10 ]. Tobacco smoke is a very complex cocktail consisting of over 6000 compounds representative of a chemical reactor where several intricate chemical processes take place during pyrolysis [ 11 – 15 ]. The mainstream smoke emitted from the mouth end of a burning cigarette is mainly produced by combustion and pyrolysis reactions as well as distillation processes in the burning tip of the cigarette when the cigarette is puffed out [ 16 ].…”

“…Although there are many complex parameters at play during cigarette smoking such as the gas-phase/liquid interface, we believe this study may simulate the characteristic behaviour of the average particulate size deposited in the lung tissues of cigarette smokers. Additionally, this contribution is part our sister articles on tobacco research aimed at providing an important piece of knowledge towards understanding tobacco [ 15 , 5 ]. Ultimately, tobacco smoke particulates and radicals are well established xenobiotics and eco-toxicants.…”