Interdigital Piezopolymer Transducers for Time of Flight Measurements with Ultrasonic Lamb Waves on Carbon-Epoxy Composites under Pure Bending Stress

Abstract

Interdigital transducers fabricated with piezopolymer film have been realized to excite ultrasonic Lamb waves in a composite laminate subjected to pure bending stresses. Lamb waves were generated and detected in a cross-ply [0°/90°] 4 mm thick carbon-fiber composite, by using two interdigital transducers in pitch-catch configuration. We demonstrate that the choice of the piezopolymer transducer technology is suitable for this type of investigation and the advantages of the proposed transducer assembly and bonding are described. A full set-up is described to determine the relationship between the time of flight of the recorded signals and the applied bending moment. Interdigital transducers were designed according to simulations of the dispersion curves, in order to operate at a central frequency of 450 kHz. This frequency corresponds to a central wavelength of 16 mm and to a group velocity of about 6000 m/s for the first symmetric guided wave mode. The variations in the time of flight of ultrasonic recorded signals were measured as a function of the variations in the bending moment. The static and dynamic load tests were in good agreement with strain gage measurements performed in the micro deformation range (0–1400 µm/m).

Analysis of Guided Wave Propagation in a Multi-Layered Structure in View of Structural Health Monitoring

“…Here, thin and flexible polymer materials such as PVDF can be used. Their thickness may be less than 100 µm, they can be poled to achieve piezo-electric properties, and their electrodes can be structured in the desired manner to excite the wave mode needed [42][43][44][45][46][47]. A sketch of a proposed arrangement with regard to structural integration is shown in Figure 9.…”

A time-domain spectral finite element method for acoustoelasticity: Modeling the effect of mechanical loading on guided wave propagation

“…In [4,5,6,8,7,10,26,36,41,44,45], the TOECs are obtained for aluminum and other metals. Transversely isotropic materials are specifically treated in [18,46,49,53]. Most of the presented methods rely on pitch-catch time of flight measurements, which is potentially subject to poor robustness [36].…”

A Versatile Analog Electronic Interface for Piezoelectric Sensors Used for Impacts Detection and Positioning in Structural Health Monitoring (SHM) Systems

“…The event of an impact can be detected and characterized by different types of sensors, such as piezoelectric sensors for the detection of guided ultrasonic waves [11][12][13][14][15] or stress/deformation through optoelectronic sensors, such as Fiber Bragg Gratings [16][17][18][19] and others. Obviously, each type of sensor needs an appropriate electronic front-end.…”

“…As previously discussed, the problem with the design of the AFE is that of choosing the type of piezoelectric sensor and the analog processing chain capable of extracting useful information for the application of triangulation algorithms for estimating the position of the impact [25][26][27][28] and for the determination of energy to assess any damage and prognostics [6,15].…”