Fully reversible, dislocation-based compressive deformation of Ti3SiC2 to 1 GPa

Abstract

Dislocation-based deformation in crystalline solids is almost always plastic. Here we show that polycrystalline samples of Ti3SiC2 loaded cyclically at room temperature, in compression, to stresses up to 1 GPa, fully recover on the removal of the load, while dissipating about 25% (0.7 MJ x m(-3)) of the mechanical energy. The stress-strain curves outline fully reversible, rate-independent, closed hysteresis loops that are strongly influenced by grain size, with the energy dissipated being significantly larger in the coarse-grained material. At temperatures greater than 1,000 degrees C, the loops are open, the response is strain-rate dependent, and cyclic hardening is observed. This hitherto unreported phenomenon is attributed to the reversible formation and annihilation of incipient kink bands at room-temperature deformation. At higher temperatures, the incipient kink bands dissociate and coalesce to form regular irreversible kink bands. The loss factor for Ti3SiC2 is higher than most woods, and comparable to polypropylene and nylon. The technological implications of having a stiff, lightweight machinable ceramic that can dissipate up to 25% of the mechanical energy per cycle are discussed.

The M+1AX phases: Materials science and thin-film processing

“…Other unexplored properties include superconductivity and magnetism. For mechanical properties, Barsoum's "incipient kink band" model [302] requires testing by, for example, in-situ nanoindentation in a TEM.…”

Superconductivity at 7.3 K in Ti2InN

“…an unexpected combination of metallic and ceramic attributes. These combinations of properties place this class of materials as highly functional with the following aspects: (i) MAX phases can be easily machined like metals, (ii) they have good oxidation properties like ceramics, and (iii) they are excellent electrical and thermal conductors [1][2][3][4][5][6][7][8]. Among the ternary phases almost all the studies are concerned with carbide properties, but with few works on nitrides.…”

Current-Activated, Pressure-Assisted Infiltration: A Novel, Versatile Route for Producing Interpenetrating Ceramic–Metal Composites

“…MAX phases are kinking-nonlinear elastic solids which can dissipate significant amount of energy during cyclic loading due to the formation and annihilation of fully reversible incipient kink bands. [31] Previous investigations have shown exceptional damage tolerance of MAX phase foams. [25] Specifically, the compressive strength of Ti 2 AlC decreases almost linearly with increasing porosity and less rapidly when compared with common ceramics, such as Al 2 O 3 , Si 3 N 4 , and ZrO 2 , whose compressive strength drops dramatically with increasing porosity.…”