Experimental Study of Sidewall Rupture of Cylindrical Lithium-Ion Batteries under Radial Nail Penetration

Abstract

To understand the relationship of the sidewall rupture at different state of charge (SOC) of cylindrical cells with high specific energy, this work presents the results of radial nail penetration tests of 21700 cylindrical cells at different SOC. The thermal runaway and sidewall rupture behaviours were characterised by key performance indicators such as temperature, mass, fire behaviour, and voltage change. In addition, released gases from a subset of tests were measured using the Fourier transform infrared spectroscopy. The change in the internal structure of another subset of cells after the test was observed by X-ray computed tomography. The results show that the sidewall rupture still exists for tests at low SOC (< 30% SOC), but the outcome of thermal runaway and sidewall rupture is milder than those at high SOC (≥ 50% SOC). The average mass loss of cells increases with the increment of SOC. The cell casing thickness is reduced by 12.7% ± 0.3% of the fresh cell, which in combination with the reduction in the strength of the casing material at high temperatures could contribute to sidewall rupture

On the State of Usability for Lithium–Ion Batteries

“…On the experimental side, several non-invasive detection methods have been studied in recent years. For identifying mechanical defects like an open CID or delaminated electrode layers, methods like X-ray measurements and computer tomography (CT) have been validated as well-suited methods [37][38][39]. The detection of triggered CIDs is particularly crucial for a safe and fast diagnosis of batteries, as it indicates severe abuse or defects such as overcharge, high cell pressure, or high temperature and thus immediately leads to a low SOU classification [19].…”

Overview of the Thermal Runaway in Lithium-Ion Batteries with Application in Electric Vehicles: Working Principles, Early Warning, and Future Outlooks

“…Recent research on single cylindrical and single pouch cells demonstrates that a direct impact perpendicular to the electrode plane will weaken and fracture the thin electrode layers covering the current collector, allowing the separator layer and electrolyte to mix into the electrode (Figure ). − This will lead to an internal short circuit and cause ignition during the discharge process.…”