Excess molar volumes of ternary liquid mixtures composed of 1, 4-dioxane, o-toluidine, and aromatic hydrocarbon at temperature of 308.15K

Jangra, Sunil K.; Saini, Neeti; Yadav, J.S.; Siwach, Rajesh K.; Sharma, Dimple; Sharma, V.K.

doi:10.1016/j.molliq.2010.12.004

Cited by 4 publications

(4 citation statements)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…All the chemicals were used without further purification. Densities of pure liquids were measured at four temperatures inside T = [283.15 to 318.15] K and well compared with open literature data ,,,− in Table .…”

Section: Methodsmentioning

confidence: 99%

See 1 more Smart Citation

Densities and Excess Molar Volumes for the Binary and Ternary Systems of (1,4-Dioxane, 1-Propanol or 2-Propanol, and 1,2-Dichloroethane) at T = (288.15 to 318.15) K. Experimental Measurements and Prigogine–Flory–Patterson Modeling

Benabida

Belaribi

2018

J. Chem. Eng. Data

View full text Add to dashboard Cite

Densities, ρ, and molar excess volumes, V E , for binary and ternary systems of (1,4-dioxane, 1-propanol or 2-propanol, and 1,2dichloroethane) were measured over the whole composition range, at T = [288.15, 298.15, 308.15, and 318.15] K, and atmospheric pressure. The density measurements were performed using an Anton Paar vibrating U-tube densimeter. The binary mixtures of 1-propanol or 2-propanol with 1,4-dioxane present positive V E values over the whole composition and working temperature ranges, whereas with 1,2-dichloroethane even negative V E values are observed at higher alcohol mole fraction and at lower temperature. The V E magnitude, for the alkanol containing binary mixtures, increases as the temperature increases and decreases for 1,4-dioxane + 1,2-dichloroethane. The experimental V E data, for all the binary mixtures, were fitted to the Redlich−Kister equation. For all the ternary mixtures, the excess molar volumes are found to be positive and increase with the temperature increase. The experimental ternary V E values were fitted to the Cibulka equation. The capability of the Prigogine−Flory−Patterson theory (PFP model) in predicting excess volume, for binary mixtures, was tested. Comparison of the experimental V E values with the PFP calculations, for all the binary mixtures, at 298.15 K, was graphically presented.

show abstract

Section: Methodsmentioning

confidence: 99%

“… a Ref . b Ref . c Ref . d Ref . e Ref . f Ref . g Ref . h Ref . i Ref . j Ref . k Ref . l Ref . m Ref . n Ref . o Ref . p Ref . q Ref . r Standard uncertainties u are u ( T ) = 0.01 K, u ( p ) = 5 kPa, and u r (ρ) = 0.0005. …”

Section: Methodsmentioning

confidence: 99%

Densities and Excess Molar Volumes for the Binary and Ternary Systems of (1,4-Dioxane, 1-Propanol or 2-Propanol, and 1,2-Dichloroethane) at T = (288.15 to 318.15) K. Experimental Measurements and Prigogine–Flory–Patterson Modeling

Benabida

Belaribi

2018

J. Chem. Eng. Data

View full text Add to dashboard Cite

show abstract

“…The chemicals were used without further purification. Density measurements for the pure liquids were carried out at the temperature range T = 283.15–318.15 K and at atmospheric pressure, and well compared with open literature data − in Table . The observed deviations between our experimental density values, and the literature data are small and would probably be due to the difference in the origin and purity of the compounds and also to other conditions such as humidity and pressure.…”

Section: Methodsmentioning

confidence: 99%

“… a Ref . b Ref . c Ref . d Ref . e Ref . f Ref . g Ref . h Ref . i Ref . j Ref . k Ref . l Ref . m Ref . n Ref . o Ref . p Ref . q The pressure for the density measurement was 101.3 kPa; the standard uncertainties, u , are u ( T ) = 0.01 K, u ( p ) = 5 kPa, and u r (ρ) = 0.0005. …”

Section: Methodsmentioning

confidence: 99%

Densities and Excess Molar Volumes of the Ternary System (1,4-Dioxane + 2-Propanol + 1,1,2,2-Tetrachloroethane) at T = 288.15–318.15 K and at Atmospheric Pressure: Experimental Measurements and Prigogine–Flory–Patterson Modeling

2019

View full text Add to dashboard Cite

HAL is a multidisciplinary open access archive for the deposit and dissemination of scientific research documents, whether they are published or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers. L'archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d'enseignement et de recherche français ou étrangers, des laboratoires publics ou privés.

show abstract

Topological Investigations of Excess Heat Capacities of Binary and Ternary Liquid Mixtures Containing o-Chlorotoluene, Amides and Cyclohexane at 298.15, 303.15 and 308.15 K

2015

View full text Add to dashboard Cite

Excess molar volumes of ternary liquid mixtures composed of 1, 4-dioxane, o-toluidine, and aromatic hydrocarbon at temperature of 308.15K

Cited by 4 publications

References 19 publications

Densities and Excess Molar Volumes for the Binary and Ternary Systems of (1,4-Dioxane, 1-Propanol or 2-Propanol, and 1,2-Dichloroethane) at T = (288.15 to 318.15) K. Experimental Measurements and Prigogine–Flory–Patterson Modeling

Densities and Excess Molar Volumes for the Binary and Ternary Systems of (1,4-Dioxane, 1-Propanol or 2-Propanol, and 1,2-Dichloroethane) at T = (288.15 to 318.15) K. Experimental Measurements and Prigogine–Flory–Patterson Modeling

Densities and Excess Molar Volumes of the Ternary System (1,4-Dioxane + 2-Propanol + 1,1,2,2-Tetrachloroethane) at T = 288.15–318.15 K and at Atmospheric Pressure: Experimental Measurements and Prigogine–Flory–Patterson Modeling

Topological Investigations of Excess Heat Capacities of Binary and Ternary Liquid Mixtures Containing o-Chlorotoluene, Amides and Cyclohexane at 298.15, 303.15 and 308.15 K

Contact Info

Product

Resources

About