Effect of tool epilamation on nonuniformity of hardening and hardness of material in case of centrifugal treatment

Selemeneva, O. V.; Selemenev, M.F.; Frolenkova, L. Yu.; Tarapanov, Alexander; Kuznetsov, Yu. А.; Кравченко, И. Н.

doi:10.31044/1684-2499-2018-10-29-35

Cited by 4 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The decrease in wear of parts with thin-film coatings is associated with a decrease in roughness and better protection of rubbing surfaces from oxidation and hydrogen penetration. According to experimental studies [18,19], the surface roughness during epilamation decreases by a factor of 2-2.5, which is associated with the filling of microdepressions and microroughnesses of the surface during epilamation with the epilam film (Fig. 3).…”

Section: Introductionmentioning

confidence: 97%

Modeling of the Mechanism of Action of Epilame Film in the Process of Processing

Zvyagina¹,

Selemenev²,

Frolenkova³

et al. 2022

adeletters

View full text Add to dashboard Cite

The article discusses the mechanism of action of the epilam film during the operation of epilated drills and the influence of cutting conditions, processing conditions on their condition. Tribological tests were carried out using a special installation, where the test conditions are close to the conditions characteristic of the drilling process. Based on the results of the experiment, it was found that the effectiveness of epilam film directly depends on the cutting speed, which determines the temperature in the contact zone. Research has shown that use of oil-based LCTF MR-7 (МР-7) has the best effect on the state of epilam coating.

show abstract

Section: Introductionmentioning

confidence: 97%

Modeling of the Mechanism of Action of Epilame Film in the Process of Processing

Zvyagina¹,

Selemenev²,

Frolenkova³

et al. 2022

adeletters

View full text Add to dashboard Cite

show abstract

Experimental modeling of the mechanism of epilame film action during processing

Zvyagina

Selemenev

Tarapanov

et al. 2022

INTERNATIONAL CONFERENCE ON INFORMATICS, TECHNOLOGY, AND ENGINEERING 2021 (InCITE 2021): Leveraging Smart Engineering

View full text Add to dashboard Cite

Deposition process of an epilam film during surface plastic deformation

Barsukov

Selemenev

DANILCHENKO

et al. 2021

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

The article deals with the conditions of contact between the tool and the nominal surface during surface - plastic processing with balls due to centrifugal force. The dependences reflecting the impact of the oblique impact of the ball on the surface are given. It has been established that the deformation process can be significantly influenced by the epilamic coating of the working elements of the tool, which significantly changes the energies of the interaction of the contacting surfaces.

show abstract

Effect of tool epilamation on nonuniformity of hardening and hardness of material in case of centrifugal treatment

Cited by 4 publications

References 0 publications

Modeling of the Mechanism of Action of Epilame Film in the Process of Processing

Modeling of the Mechanism of Action of Epilame Film in the Process of Processing

Experimental modeling of the mechanism of epilame film action during processing

Deposition process of an epilam film during surface plastic deformation

Contact Info

Product

Resources

About