Dynamic mechanical properties of oil palm microfibril‐reinforced natural rubber composites

Abstract

ABSTRACT:The dynamic mechanical properties of macro and microfibers of oil palm-reinforced natural rubber (NR) composites were investigated as a function of fiber content, temperature, treatment, and frequency. By the incorporation of macrofiber to NR, the storage modulus (E') value increases while the damping factor (tan d) shifts toward higher temperature region. As the fiber content increases the damping nature of the composite decreases because of the increased stiffness imparted by the natural fibers. By using the steam explosion method, the microfibrils were separated from the oil palm fibers. These fibers were subjected to treatments such as mercerization, benzoylation, and silane treatment. Resorcinolhexamethylenetetramine-hydrated silica was also used as bonding agent to increase the fiber/matrix adhesion. The storage modulus value of untreated and treated microfibril-reinforced composites was higher than that of macrofiber-reinforced composites. The T g value obtained for this microfibril-reinforced composites were slightly higher than that of macrofiber-reinforced composites. The activation energy for the relaxation processes in different composites was also calculated. The morphological studies using scanning electron microscopy of tensile fracture surfaces of treated and untreated composites indicated better fiber/ matrix adhesion in the case of treated microfibrilreinforced composites. Finally, attempts were made to correlate the experimental dynamic properties with the theoretical predictions.

Synthesis and characterization of high cis‐polymyrcene using neodymium‐based catalysts

“…Figure ii shows that Run 1 has a higher M n value and lower tan δ, in contrast with Runs 4–6 with lower molecular mass and higher tan δ. This behaviour is explained in terms of the mobility of shorter chains that produce a higher viscous component and hence a higher flow . The damping factor of natural rubber was lower than the polymyrcene damping factors, whereas high‐ cis polybutadiene has the lowest damping factor.…”

The Effect of Bi-Functionalized MMT on Morphology, Thermal Stability, Dynamic Mechanical, and Tensile Properties of Epoxy/Organoclay Nanocomposites

“…The storage modulus (E ), loss modulus (E"), and tan delta curves of the pristine epoxy and epoxy nanocomposites are shown in Figure 12, and the obtained DMA parameters data are summarized in Tables 6 and 7. The ability of the material to store or return energy is represented by E and provides valuable insight on the load bearing capacity [46], stiffness [23], degree of crosslinking [47], and fiber/matrix interfacial bonding [48]. The E decreases as the temperature increases with a steep change in modulus was observed in the temperature range of 60-90 • C. This can be denoted as the glass transition (T g ) region or α relaxation of the polymer whereby it represents the movement of the polymer main chain.…”

Mechanical, electrical, and thermal analysis of sisal fibril/kenaf fiber hybrid polyester composites

“…Zheng et al experimented on sisal microfibril/gelatin biomass composites and reported increased tensile strength and decreased degradation ratio with increase in sisal fibril content. Joseph et al studied the dynamic mechanical properties of oil palm microfibril reinforced natural rubber composites and improved properties were observed for microfibril reinforced properties than that of macrofiber reinforced composites.…”