Design of Umbrella shape single element patch antenna with high gain and high efficiency for 5G wireless communication in 28 GHz

Ahmad, Iftikhar; Sun, Houjun; Ali, Qasim; Samad, Abdul

doi:10.1109/ibcast47879.2020.9044577

Cited by 19 publications

(7 citation statements)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The antenna [26] has a wide bandwidth compared to the other antennas, but its gain is lower than the other antennas with the disadvantage of its larger size. On the other hand, the gain and efficiency of the antenna [25] are higher than the other antennas except the proposed one, but it has two disadvantages: its larger size and its low bandwidth. Furthermore, the performance of the proposed antenna is much better than the other antennas, except for the 𝑆 11 and its bandwidth.…”

Section: Resultsmentioning

confidence: 87%

Design of a microstrip antenna patch with a rectangular slot for 5G applications operating at 28 GHz

Didi

Halkhams²,

Fattah

et al. 2022

TELKOMNIKA

View full text Add to dashboard Cite

In this paper, we present a study and design of a rectangular-shaped microstrip patch antenna with a rectangular shaped slot at the operating frequency is 28GHz, for fifth generation (5G) wireless applications, using the microstrip line technique for feeding. The objective of this slot is to contribute to the improvement of antenna performance. This antenna is built on a Roger RT duroid 5880 type substrate having a relative permittivity equal to 2.2, a height of h = 0.5 mm, and a loss tangent of 0.0009. The compact size of this antenna is 4.2 mm × 3.3 mm × 0.5 mm. The simulations of this antenna were performed using high-frequency structure simulator (HFSS) and computer simulation technology (CST) software whose main purpose is to confirm the results obtained for this proposed antenna. The results obtained during these simulations are as follows: resonant frequency of 27.97 GHz and reflection coefficient (𝑆 11 ) of -20.95 dB, bandwidth of 1.06 GHz, a gain of 7.5 dB, radiated power of 29.9 dBm, and efficiency of 99.83%. These results obtained by this proposed antenna are better than those obtained from already existing antennas that are published in current scientific journals. Consequently, this antenna is likely to satisfy the needs for 5G wireless communication applications.

show abstract

Section: Resultsmentioning

confidence: 87%

Design of a microstrip antenna patch with a rectangular slot for 5G applications operating at 28 GHz

Didi

Halkhams²,

Fattah

et al. 2022

TELKOMNIKA

View full text Add to dashboard Cite

show abstract

“…It has the characteristics of open aperture, large size, high gain, and narrow beam, and is not suitable for wide beam circular polarization design. The circularly polarized antenna realized by waveguide circular polarizer has the characteristics of single feed point wide polarization [15][16][17].…”

Section: Radiation Element 31 Design Of Circularly Polarized Antennamentioning

confidence: 99%

A Novel Design of Antenna Array with Two K-Band Circularly Polarized燗ntenna

Liu¹,

Li²,

Yu³

et al. 2023

Computers, Materials &Amp; Continua

View full text Add to dashboard Cite

As an important part of phased array system, the research on phased array antenna is very necessary. The phased array antenna achieves the scanning beam adaptively by regulating the phase difference between each array element. In this paper, a dual K-band circularly polarized antenna with high broadband, broadband beam, wide axial ratio bandwidth and high radiation efficiency is designed. We combine with the advantages of slot antenna and aperture antenna, use multimode waveguide cavity structure to design an aperture antenna, which is fed to waveguide circular polarizer by slot coupling in order to realize circular polarization radiation. Meanwhile, it has the characteristics of broadband, broadband beam, wide axial ratio bandwidth and high radiation efficiency. A slit antenna is designed by using a multimode waveguide cavity structure and a slit coupling feed to a waveguide circular polarizer is used to achieve circularly polarized radiation. The designed antenna consists of two K-band circularly polarized antenna units, and the spacing between the two units is 9.5 mm, which is fed by a K-band T/R module (Transmitter/Receiver module). In order to study the performance of the pattern in the case of the research group, the 2-unit structure is established. The simulation results of frequency-axial ratio bandwidth are given, and the simulation result of the antenna array is shown. The practical results of antenna design and test are also given.

show abstract

“…An umbrella shaped microstrip patch antenna is presented in paper. 27 The umbrella-shaped patch is created by incorporating a semicircular slot into a semicircular patch and is powered by a 50 Ohm feed line. Figure 17 depicts the antenna's geometry.…”

Section: Semicircular Patch Antennamentioning

confidence: 99%

“…Semicircular low profile antenna 27 Simple planar low profile structure, less complexity, high efficiency, wide bandwidth Limited gain, high side lobe levels and wide beamwidth Magnetoelectric dipole antenna with printed ridge gap waveguide 81 Suppressed side lobes or back lobes, wide bandwidth, high front to back ratio, low cross polarization Complex fabrication, high cost, high profile Fabry-Perot antenna 15,46 High directivity, good efficiency Small pattern bandwidth Spoof surface plasmon polaritons 92 High radiation efficiency and low transmission line losses…”

Section: Complex Fabrication Limited Bandwidthmentioning

confidence: 99%

“…Feeding losses or mismatching losses can be minimized using several methods such as reflect arrays, 24 substrate integrated waveguide and substrate integrated cavity based feeding, 22,25,26 incorporating semicircular slots at the inter-connection point between feed and patch, 27 ridge gap waveguide, 28 aperture coupled feeding, 16 SPP waveguide feed, 29 rotatable feed lines with a 90 • angle, 30 microstrip gradient balun line, 31 ring shaped slot in patch, 32 defected ground structure, 33,34 adjusting feed point location 13 and many more.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Efficiency enhancement techniques of microwave and millimeter‐wave antennas for 5G communication: A survey

Nahar

Rawat

2022

Trans Emerging Tel Tech

View full text Add to dashboard Cite

Efficiency is a critical antenna parameter that describes how well an antenna emits and accepts electromagnetic signals. When an antenna has poor efficiency, the input power is only partially radiated and is primarily wasted due to internal losses such as conduction, dielectric, mismatching, and several other losses within the antenna. In order to enhance signal quality, a communication system requires an antenna with high efficiency and gain. The fifth-generation wireless system will use millimeter wave spectrum along with sub 1 GHz and sub 6 GHz bands to fulfill wide bandwidth, ultra-high-speed, and low latency requirements of 5G communication. Compact low-profile antenna with high radiation efficiency, high gain, and wideband characteristics are required to support bandwidth requirements of 5G and mitigate the signal degradation due to high link losses caused by environmental absorptions at the millimeter-wave (mm-wave) spectrum. Compact planar antennas have become an important part of modern wireless communication equipment, but these antennas are associated with many issues like low efficiency, poor gain, small radiation resistance, and high cross-polarization, which is due to the increased conductor and dielectric losses, surface wave losses and so forth. Various techniques need to be employed for the improvement of the efficiency of the antenna, which results in high gain low loss antenna characteristics. This article presents the survey of various efficiency enhancement techniques for 5G antennas and a review of structures that provides good radiation efficiency for 5G communications.

show abstract

Design of Umbrella shape single element patch antenna with high gain and high efficiency for 5G wireless communication in 28 GHz

Cited by 19 publications

References 19 publications

Design of a microstrip antenna patch with a rectangular slot for 5G applications operating at 28 GHz

Design of a microstrip antenna patch with a rectangular slot for 5G applications operating at 28 GHz

A Novel Design of Antenna Array with Two K-Band Circularly Polarized燗ntenna

Efficiency enhancement techniques of microwave and millimeter‐wave antennas for 5G communication: A survey

Contact Info

Product

Resources

About