Comparison of Thermal Models for Ground-Mounted South-Facing Photovoltaic Technologies: A Practical Case Study

Abstract

This paper examines the thermal properties of free-standing, ground-installed, south-facing crystalline and amorphous silicon photovoltaic modules, the remaining energy and the energy generation of the modules, in ideal and actual summer weather conditions. This work studies the algorithms in other studies used to describe the thermal processes occurring on the surface of photovoltaic modules. Using accurate devices and real, measured data, the deviations and the inaccuracies of theoretical approaches are investigated. The emphasis of the present study is to improve the simulation accuracy of the total emitted long-wave radiation at the module surface and to show the appropriate overall convection coefficient values for ground-mounted south-facing photovoltaic technologies. The innovative aspect of the present paper is an improved model resulting from an improved convective heat transfer and net long-wave radiation calculation. As a result of this research, algorithms describing the energy fluxes were developed. These algorithms have a 1-3% better accuracy of the net long-wave radiation calculations at the module surface. The rate of net energy exchange by convection at the module surface could be improved by 10-12% compared to the previous literature.

Design of a Low-Cost PV Emulator Applied for PVECS

“…In general, commercial PV modules are housed on metal, and are then covered with anti-reflective coating to minimize the reflection as well as a special laminate for mechanical protection. For the PV system representation, two types of the PV model are considered either the electrical circuit model, which includes the PV electricity model and the PV thermal model [34,35], or the interpolation model. Figure 2 presents a description of the PV model type in PV emulator applications.…”

Optimal Operation Strategies into Deregulated Markets for 50 MWe Parabolic Trough Solar Thermal Power Plants with Thermal Storage

“…In [4] a thermal model of electricity production by renewable resources is developed. In [5] an optimization model is used to calculate the cost-effectiveness of PT plants' solar heating systems through different constructive hypotheses and operations.…”

Unsupervised Fault Detection and Analysis for Large Photovoltaic Systems Using Drones and Machine Vision

“…The solar cell's voltage, which is a result of its built-in electric fields, together with the current, provides the power that can be produced by the solar cell. PV modules produce an amount of electricity that depends on the prevailing natural factors, the type and the composition of the module, and the combined effect of the installation [2]. One big limitation for solar (and wind) power is that it only generates electricity when the sun is shining (or the wind is blowing)-falling short at peak demand times like the evenings.…”

“…In addition, temperature fluctuation is an important factor in PV modules due to changes in solar irradiance and temperature. For example, crystalline PV modules have a 0.5% reduction in efficiency when the temperature is increased by 1 • C [2]. Solar radiation is the main component of the heat balance of PV modules.…”

“…Solar radiation is the main component of the heat balance of PV modules. Solar radiation influences the output power of the PV module, radiation heat exchanges and convective heat exchanges [2]. Additionally, because of fluctuating weather conditions and/or a lack of abundant historical data, a growing generation share of renewable energy (e.g., wind and solar) significantly complicates power system operations hence imposing more severe system constraints (voltage, frequency, etc.).…”