Characterization of table salt samples from different origins and ESR detection of the induced effects due to gamma irradiation

Abdou, Saleh M.; Moharam, Hany

doi:10.1088/1742-6596/1253/1/012036

Cited by 11 publications

(8 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The X-ray diffraction of NaCl is presented in Figure 6 . The characterization peaks of NaCl are very close to the corresponding report in Ref [ 57 ]. NaCl has ionic bonds, and the ionic radius of Na + and Cl − is 0.97 and 1.81

, respectively.…”

Section: Methodssupporting

confidence: 86%

Measurement Modulus of Elasticity Related to the Atomic Density of Planes in Unit Cell of Crystal Lattices

et al. 2020

View full text Add to dashboard Cite

Young’s modulus (E) is one of the most important parameters in the mechanical properties of solid materials. Young’s modulus is proportional to the stress and strain values. There are several experimental and theoretical methods for gaining Young’s modulus values, such as stress–strain curves in compression and tensile tests, electromagnetic-acoustic resonance, ultrasonic pulse echo and density functional theory (DFT) in different basis sets. Apparently, preparing specimens for measuring Young’s modulus through the experimental methods is not convenient and it is time-consuming. In addition, for calculating Young’s modulus values by software, presumptions of data and structures are needed. Therefore, this new method for gaining the Young’s modulus values of crystalline materials is presented. Herein, the new method for calculating Young’s modulus of crystalline materials is extracted by X-ray diffraction. In this study, Young’s modulus values were gained through the arbitrary planes such as random (hkl) in the research. In this study, calculation of Young’s modulus through the relationship between elastic compliances, geometry of the crystal lattice and the planar density of each plane is obtained by X-ray diffraction. Sodium chloride (NaCl) with crystal lattices of FCC was selected as the example. The X-ray diffraction, elastic stiffness constant and elastic compliances values have been chosen by the X’Pert software, literature and experimental measurements, respectively. The elastic stiffness constant and Young’s modulus of NaCl were measured by the ultrasonic technique and, finally, the results were in good agreement with the new method of this study. The aim of the modified Williamson–Hall (W–H) method in the uniform stress deformation model (USDM) utilized in this paper is to provide a new approach of using the W–H equation, so that a least squares technique can be applied to minimize the sources of errors.

show abstract

, respectively.…”

Section: Methodssupporting

confidence: 86%

Measurement Modulus of Elasticity Related to the Atomic Density of Planes in Unit Cell of Crystal Lattices

et al. 2020

View full text Add to dashboard Cite

show abstract

“…Consequently, this outcome strongly suggests that all the samples exhibit a face-centred cubic structure [ 22 ], consistent with JCPDS card no. 78–0751 [ 23 ].…”

Section: Resultsmentioning

confidence: 99%

Mineral composition, crystallinity and dielectric evaluation of Bamboo Salt, Himalaya Salt, and Ba’kelalan salt content

Meng,

Sharifah Robiah Mohamad,

Mohd Nasir

et al. 2024

Heliyon

View full text Add to dashboard Cite

“…1) [42,43]. On the other hand, other diffraction peaks observed at 45.2 • , 56.2 • ; and 66 • may have originated from NaCl crystallization in the scaffolds [44]. Interestingly, the nonmineralized PL/OL scaffold also had the same diffraction patterns.…”

Section: Xrd Analysismentioning

confidence: 90%

Biomimetic mineralization of platelet lysate/oxidized dextran cryogel as a macroporous 3D composite scaffold for bone repair

Şeker,

Aral,

Elçin

et al. 2024

Biomed. Mater.

View full text Add to dashboard Cite

Scaffold development approaches using autologous sources for tissue repair are of great importance in obtaining bio-active/-compatible constructs. Platelet-rich plasma (PRP) containing various growth factors and platelet lysate (PL) derived from PRP are autologous products that have the potential to accelerate the tissue repair response by inducing a transient inflammatory event. Considering the regenerative capacity of PRP and PL, PRP/PL-based scaffolds are thought to hold great promise in tissue engineering by providing an ideal autologous growth factor source and mechanical support for cells. Here, a bio-mineralized PRP-based scaffold was developed using oxidized dextran (OD) and evaluated for future application in bone tissue engineering. Prepared PL/OD scaffolds were incubated in simulated body fluid (SBF) for 7, 14 and 21 day periods. Mineralized PL/OD scaffolds were characterized using Fourier transform infrared spectroscopy (FTIR), X-ray diffraction spectroscopy (XRD), scanning electron microscopy (SEM), thermogravimetric analysis (TGA), porosity and compression tests. SEM and EDX analyses revealed mineral accumulation on the PL/OD scaffold as a result of SBF incubation. In vitro cytotoxicity and in vitro hemolysis tests revealed that the scaffolds were non-toxic and hemocompatible. Additionally, human osteoblasts (hOBs) exhibited good attachment and spreading behavior on the scaffolds and maintained their viability throughout the culture period. The alkaline phosphatase activity assay and calcium release results revealed that PL/OD scaffolds preserved the osteogenic properties of hOBs. Overall, findings suggest that mineralized PL/OD scaffold may be a promising scaffold for bone tissue engineering.

show abstract

Characterization of table salt samples from different origins and ESR detection of the induced effects due to gamma irradiation

Cited by 11 publications

References 8 publications

Measurement Modulus of Elasticity Related to the Atomic Density of Planes in Unit Cell of Crystal Lattices

Measurement Modulus of Elasticity Related to the Atomic Density of Planes in Unit Cell of Crystal Lattices

Mineral composition, crystallinity and dielectric evaluation of Bamboo Salt, Himalaya Salt, and Ba’kelalan salt content

Biomimetic mineralization of platelet lysate/oxidized dextran cryogel as a macroporous 3D composite scaffold for bone repair

Contact Info

Product

Resources

About