2020
DOI: 10.1016/j.chemosphere.2019.124839
|View full text |Cite
|
Sign up to set email alerts
|

Breakthrough analysis of continuous fixed-bed adsorption of sevoflurane using activated carbons

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

2
23
0

Year Published

2020
2020
2024
2024

Publication Types

Select...
7
1
1

Relationship

0
9

Authors

Journals

citations
Cited by 55 publications
(26 citation statements)
references
References 31 publications
2
23
0
Order By: Relevance
“…This is another confirmation that the sorbent is not fully saturated. Ang et al [96] observed close values for the saturation capacities in the case of the sorption of anesthetic gaseous agent on activated carbon when varying the flow rate. The rate coefficient k T (L mmol −1 h −1 ) linearly increases with the superficial velocity (between 0.32 and 2.390 L mmol −1 h −1 for LR; between 0.246 and 2.09 mmol −1 h −1 for NLR); consistently with the conclusions raised by Ang et al [96].…”
Section: Selectivity Studymentioning
confidence: 93%
See 1 more Smart Citation
“…This is another confirmation that the sorbent is not fully saturated. Ang et al [96] observed close values for the saturation capacities in the case of the sorption of anesthetic gaseous agent on activated carbon when varying the flow rate. The rate coefficient k T (L mmol −1 h −1 ) linearly increases with the superficial velocity (between 0.32 and 2.390 L mmol −1 h −1 for LR; between 0.246 and 2.09 mmol −1 h −1 for NLR); consistently with the conclusions raised by Ang et al [96].…”
Section: Selectivity Studymentioning
confidence: 93%
“…Ang et al [96] observed close values for the saturation capacities in the case of the sorption of anesthetic gaseous agent on activated carbon when varying the flow rate. The rate coefficient k T (L mmol −1 h −1 ) linearly increases with the superficial velocity (between 0.32 and 2.390 L mmol −1 h −1 for LR; between 0.246 and 2.09 mmol −1 h −1 for NLR); consistently with the conclusions raised by Ang et al [96]. In the case of base metals using melamine-functionalized SBA-15 mesoporous silica, Shabazi et al [97] reported that a maximum sorption capacity was obtained at intermediary flow rate; the relevant sorption capacities were also lower than the corresponding sorption capacities obtained in batch mode.…”
Section: Selectivity Studymentioning
confidence: 93%
“…Similar effects of inlet concentration are common in GAC systems and these have been included in several studies. Sotelo et al [47] reported an increase in the percentage of caffeine (from 77.71% to 91.74%) and diclofenac (from 58.75% to 71.54%) adsorption when the initial concentration of these compounds increased from 3 to 7 mg/L, while Ang et al [48] reported an increase in sevoflurane (an anesthetic) adsorption (from 536 ± 5 mg/g to 604 ± 9 mg/g and from 329 ± 5 to 368 ± 5 mg/g) when two different GACs (E-GAC and H-GAC, respectively) were used at inlet concentrations from 55.9 and 527.9 mg/L.…”
Section: • Inlet Cecs Concentration Effectsmentioning
confidence: 98%
“…Improving and investing in the development of scavenging systems could also mitigate the environmental effects of inhaled anesthetics. In recent years, new scavenging systems have been proposed to adsorb any waste gases on activated carbon or zeolite for subsequent reuse or destruction [35]. However, the safety and usability of these new systems, as well as the cost-effectiveness, have not yet been demonstrated [36].…”
Section: Suggestions For Mitigating the Impact Of Inhaled Anestheticsmentioning
confidence: 99%