Biogas reforming for hydrogen production over mesoporous Ni2Ce1−O2 catalysts

Lin, K.M.; Chang, Hsing Cheng; Chang, Alex C.-C.

doi:10.1016/j.ijhydene.2012.03.130

Cited by 41 publications

(22 citation statements)

References 38 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The most commonly studied process for the reforming of biogas is dry reforming, in which the main components (CH 4 and CO 2 ) contribute to the production of syngas [28,29]. Steam reforming of biogas has also been investigated [30,31], but there are only few experimental data in the low temperature range [32].…”

Section: Introductionmentioning

confidence: 99%

Catalyst development for steam reforming of methane and model biogas at low temperature

Angeli

Turchetti

Monteleone

et al. 2016

Applied Catalysis B: Environmental

135

View full text Add to dashboard Cite

Section: Introductionmentioning

confidence: 99%

Catalyst development for steam reforming of methane and model biogas at low temperature

Angeli

Turchetti

Monteleone

et al. 2016

Applied Catalysis B: Environmental

135

View full text Add to dashboard Cite

“…There are several reports that investigate steam reforming of biogas [9,10,3]. However, these studies do not account for the presence of H 2 S, which is generally present in biogas.…”

Section: Introductionmentioning

confidence: 99%

Deactivation and regeneration of Ni catalyst during steam reforming of model biogas: An experimental investigation

Appari

Janardhanan

Bauri

et al. 2014

International Journal of Hydrogen Energy

View full text Add to dashboard Cite

This paper presents detailed study of biogas reforming. Model biogas with different levels of H 2 S is subjected to reforming reaction over supported Ni catalyst in a fixed bed reactor at 700 o C and 800 o C. In order to understand the poisoning effects of H 2 S the reactions have been initially carried out without H 2 S in the feed stream. Three different H 2 S concentrations (20, 50 and 100 ppm) have been considered in the study. The H 2 O to CH 4 ratio is maintained in such as way that CO 2 also participates in the reforming reaction. After performing the poisoning studies, regeneration of the catalyst has been studied using three different techniques i) removal of H 2 S from the feed stream ii) temperature enhancement and iii) steam treatment. Poisoning at low temperature is not recoverable just by removal of H 2 S from the feed stream. However, poisoning at high temperature is easily reversed just by removal of H 2 S from the feed stream. Unlike some previous reports [1,2], catalyst regeneration is achieved in shorter time frames for all the regeneration techniques attempted.

show abstract

“…Most recently, different alternatives for biogas utilisation have been proposed such as biomethane production [2], combustion in a dual fuel diesel engine [3,4] or as feedstock in the dry reforming of CH 4 (DRM) [5,6]. In the latter case, high CO 2 concentration, up to 50%, makes biogas a perfect choice to be used as feedstock, resulting in a suitable syngas that can be used for hydrogen production [7,8], to feed a solid oxide fuel cell [9] or for hydrocarbons synthesis via the Fischer-Tropsch process [10]. Besides this, DRM using biogas can be classified as environmentally friendly due to the renewable character of the feedstock.…”

mentioning

confidence: 99%

Effect of the synthesis conditions of Ni/Al2O3 catalysts on the biogas decomposition to produce H2-rich gas and carbon nanofibers

Llobet

Pinilla

Moliner

et al. 2015

Applied Catalysis B: Environmental

View full text Add to dashboard Cite

The utilization of biogas as carbon source for the co-production of filamentous-like materials and syngas is proposed. Catalysts with different Ni:Al molar ratios, Al 2 O 3 supports and preparation methods were synthesized. The suitability of the catalysts was analyzed considering activity, stability and carbon yield. Catalysts showed a good performance and similar results according to syngas compositions were obtained.However, some differences related to stability over time and carbon yields were detected. TPR analysis and TEM micrographs of the fresh catalysts revealed the presence of two different Ni particles: large Ni particles with low metal support interaction (MSI) that favoured the formation of encapsulating carbon and small Ni particles inserted in the Al 2 O 3 structure with a greater MSI that lead to NCs formation.Generally both kinds of Ni particles were observed in all catalysts, however their relative abundance was dramatically affected by the Al 2 O 3 employed, the preparation method and the Ni:Al molar ratio.

show abstract

Biogas reforming for hydrogen production over mesoporous Ni2Ce1−O2 catalysts

Cited by 41 publications

References 38 publications

Catalyst development for steam reforming of methane and model biogas at low temperature

Catalyst development for steam reforming of methane and model biogas at low temperature

Deactivation and regeneration of Ni catalyst during steam reforming of model biogas: An experimental investigation

Effect of the synthesis conditions of Ni/Al2O3 catalysts on the biogas decomposition to produce H2-rich gas and carbon nanofibers

Contact Info

Product

Resources

About