BEOL Cu CMP Process Evaluation for Advanced Technology Nodes

Abstract

The back end of the line (BEOL) copper (Cu) interconnect line width and spacing is decreasing with each advancement in technology node. It is important to understand how the decreasing dimensions will impact BEOL chemical mechanical planarization (CMP) process. This study is focused on evaluation of Cu CMP using three categories of slurry formulations (i.e. alumina abrasive, silica abrasive and abrasive-less) by utilizing test structures with dimensions relevant to sub-20 nm technology. The results presented in this study show the key factors driving the performance of slurry formulation (e.g. liner selectivity, defects) are strongly dependent on the copper (Cu) interconnect line width and spacing. The results show the blanket rate selectivity does not translate to equivalent selectivity on patterned structures. In addition, the slurry formulations lost selectivity to liner as interconnect width/spacing is reduced from 40 nm to 32 nm highlighting the need to account for pattern density when predicting selectivity. Furthermore, evaluation of Cu CMP slurry formulations with cobalt (Co) liner indicates that existing formulations exhibit no Cu to Co selectivity. Overall, the results on multiple interconnect dimensions from this study are very important for researchers focused on slurry formulation development and CMP modeling.

Embedded Micro-detectors for EUV Exposure Control in FinFET CMOS Technology

“…The detector's fabrication process is the same as a standard FinFET CMOS logic process. A brief description is a FinFET process [13][14][15][16][17]. First, the active region is defined by mask and forms a fin-shape substrate.…”

Model-Based Optimization of CMP Process Parameters for Uniform Material Removal Selectivity in Cu/Barrier Planarization

“…Different slurry chemistries result in different MRR of Cu and barrier materials. 12,[14][15][16][17][18][19][20][21] Xu investigated the effect of H 2 O 2 on MRR and found that the MRR of Cu increases till 10 ml of H 2 O 2 per liter of the slurry while it decreases if the concentration of H 2 O 2 is increased beyond 10 ml. 22 Cao studied the MRR of TiN, NDC, and Cu and found an optimized slurry formulation that can meet the requirements of the new integration scheme.…”

Corrosion Inhibition and the Synergistic Effect of Three Different Inhibitors on Copper Surface

“…The research hotspots also focus on the role and mechanism of chemical reactions. [5][6][7][8][9] As Cu is easily over-corroded in the CMP process, the corrosion inhibitor is added to the slurries to control the excessive corrosion on the Cu surface. A large number of studies have shown that corrosion inhibitors form an inhibitor film with sulfur or nitrogen atoms adsorb on Cu surface through physical adsorption and chemical adsorption that hinders the contact between Cu and slurry.…”