A comparative experimental study of the hygroscopic and mechanical behaviors of electrospun nanofiber membranes and solution‐cast films of polybenzimidazole

Abstract

This article reports a comparative experimental study of the hygroscopic and mechanical behaviors of electrospun polybenzimidazole (PBI) nanofiber membranes and solution-cast PBI films. Aselectrospun nonwoven PBI nanofiber mats (with the nanofiber diameter of ~250 nm) were heat-pressed under controlled temperature, pressure and duration for the study; lab-made solution-cast PBI films and commercially available PBI films (the PBI Performance Product Inc., Charlotte, NC ) were used as the control samples. Thermogravimetric and micro-tensile tests were utilized to characterize the hygroscopic (moisture absorption) and mechanical properties of the PBI nanofiber membranes at varying heat-pressing conditions, which were further compared to those of solution-cast PBI films. Experimental results indicated that the PBI nanofiber membranes carried slightly higher thermal stability and less hygroscopic properties than those of solution-cast PBI films. In addition, heat-pressing conditions significantly influenced the mechanical properties of the resulting PBI nanofiber membranes. The stiffness and tensile strength increase with increasing either the heat-pressing pressure or duration, and relevant mechanisms were explored. The present study provides a rational understanding of the hygroscopic and mechanical behaviors of electrospun This article is protected by copyright. All rights reserved. This is the author manuscript accepted for publication and has undergone full peer review but has not been through the copyediting, typesetting, pagination and proofreading process, which may lead to differences between this version and the Version of Record. Please cite this article as

Green Synthesis of Soy Protein Nanocomposites: Effects of Cross-Linking and Clay Nanoparticles on the Mechanical Performance

“…Thus, the nominal/effective areal size of the microtensile test specimens was 10 mm × 50 mm. During a uniaxial tensile test, a displacement control method with the constant loading rate of 2 mm/min was maintained and at least three specimens were tested in each case of the SPI-OS film specimens. − …”

Negative Thermal Expansion HfV2O7 Nanostructures for Alleviation of Thermal Stress in Nanocomposite Coatings

“…The stress response of PBI at temperatures below 130 °C is dominated by its hygroscopicity (Figure S6). PBI has a high affinity for moisture owing to the hydrogen bonds formed between water and nitrogen and N–H groups in PBI frameworks and can absorb as much as 15 wt % of water at equilibrium. − As the temperature increases during the heating process, the evaporation of water results in the shrinkage of the PBI film, which gives rise to tensile stress in the film when constrained by the underlying substrate. At temperatures above 130 °C, the absorbed water has completely evaporated, and the observed stress behavior stems solely from the intrinsic thermal expansion behavior of PBI.…”

Tailoring the Surface Properties of Micro/Nanofibers Using 0D, 1D, 2D, and 3D Nanostructures: A Review on Post‐Modification Methods

“…Nanofibrous membranes submitted to heat‐press treatment have shown a great enhancement of mechanical properties, allowing tailoring pore size and pore distribution as well as the fusion and overlapping of interconnected spots, which in turn can enhance the mechanical strength and structural integrity. [ 115–117 ] As presented by Lee and collaborators, [ 113 ] a slight temperature change can result in improved elongation at break and tensile strength, as shown in Figure a. Setting the nanofibrous membrane between two flat metal plates in hydraulic hot‐press can perform the hot‐press treatment.…”