No abstract

a b s t r a c tThe substructure of near-alpha Ti-Al-Sn-Zr-Mo-Si alloys containing up to 12.5 at% aluminum was studied by transmission electron microscopy (TEM). It was shown that long-range order sections are formed at aging temperatures up to 500 1C in alloys, high in aluminum, and the ordered phase is formed by the nucleation and growth mechanism at 700 1C aging temperatures. Causes of changing the phase transformation mechanism have been discussed, and the relationship between the structure and properties of alloys, depending on modes of heat treatment has been analyzed. Also the influence of aluminides and silicides precipitation on the mechanical alloy properties after aging was examined. It was shown that the aluminide formation led to a slight hardening and a significant viscosity decrease. The silicide particles formation reduced the heat resistance properties, due to the depletion of the solid solution by silicon.

The research demonstrates microstructural changes and development of specific texture in Ti-6Al-4V specimens produced by electron beam melting (EBM) under different conditions. The effect of two factors, namely, raw material (powder) recycling and hot isostatic pressing (HIP), on the EBM produced samples structure and properties, has been explored. The as-printed and treated samples were investigated using electron backscattered diffraction (EBSD) analysis. Modification of mechanical properties after the EBM and HIP are explained by the EBSD data on microstructural phenomena and phase transformations. The work is devoted to assessing the possibility of reusing the residual titanium alloy powder for the manufacture of titanium components by the combination of EBM and HIP methods.

One of the major challenges of implantology is to design nanoscale modifications of titanium implant surfaces inducing osseointegration. The aim of this study was to investigate the behavior of rat osteoblasts cultured on anodized TiO2 nanotubes of different crystallinity (amorphous and anatase phase) up to 24 days. TiO2 nanotubes were fabricated on VT1–0 titanium foil via a two-step anodization at 20 V using NH4F as an electrolyte. Anatase-phase samples were prepared by heat treatment at 500 °C for 1 h. VT1–0 samples with flat surfaces were used as controls. Primary rat osteoblasts were seeded over experimental surfaces for several incubation times. Scanning electron microscopy (SEM) was used to analyze tested surfaces and cell morphology. Cell adhesion and proliferation were investigated by cell counting. Osteogenic differentiation of cells was evaluated by qPCR of runt-related transcription factor 2 (RUNX2), osteopontin (OPN), integrin binding sialoprotein (IBSP), alkaline phosphatase (ALP) and osteocalcin (OCN). Cell adhesion and proliferation, cell morphology and the expression of osteogenic markers were affected by TiO2 nanotube layered substrates of amorphous and anatase crystallinity. In comparison with flat titanium, along with increased cell adhesion and cell growth a large portion of osteoblasts grown on the both nanostructured surfaces exhibited an osteocyte-like morphology as early as 48 h of culture. Moreover, the expression of all tested osteogenic markers in cells cultured on amorphous and anatase TiO2 nanotubes was upregulated at least at one of the analyzed time points. To summarize, we demonstrated that amorphous and anodized TiO2 layered substrates are highly biocompatible with rat osteoblasts and that the surface modification with about 1500 nm length nanotubes of 35 ± 4 (amorphous phase) and 41 ± 8 nm (anatase phase) in diameter is sufficient to induce their osteogenic differentiation. Such results are significant to the engineering of coating strategies for orthopedic implants aimed to establish a more efficient bone to implant contact and enhance bone repair.

No abstract