No abstract

Space manipulators which have a similar symmetrical structure with seven revolute joints, such as the space station remote manipulator system (SSRMS), can be called SSRMS-type space manipulators. The analytical inverse kinematics of an SSRMS-type manipulator can be solved by locking a single joint; the locked joint (joint 1, 2, 6, or 7) can be determined by configuration analysis. Although widely used in establishing the kinematics of SSRMS-type manipulators, the Denavit-Hartenberg (DH) method has a singular problem when two adjacent joint axes are nearly parallel. To avoid this problem, this paper proposes a novel analytical inverse kinematics method for SSRMS-type manipulators based on the product of exponentials (POE) formula and the Paden-Kahan subproblem. Because of the symmetrical structure, an SSRMS-type manipulator degrades to two kinds of 6-degree-of-freedom (DOF) manipulators when locking a single joint (joint 1, 2, 6, or 7). The analytical inverse kinematics of these two kinds of 6-DOF manipulators is solved by combining the Paden-Kahan subproblems and geometric and algebraic methods, respectively. The proposed approach is not only singularity free compared with the traditional DH-based methods but also more accurate than the POE-based numerical solution. The simulation results verify the efficiency of the proposed approach.

A thermostat is a type of contact inductive device. It has the features of being compact, lightweight, and high temperature control precision. A scheme for using a thermostat as a control device in the active electrical heating and temperature control circuit of the spacecraft is proposed. It is in line with the design requirement of the spacecraft thermal control system when the computer controlled heater-system is limited. Compared with the computer-controlled heater system, the thermostat-controlled heater system has the advantages of simple configuration, easy implementation, and high reliability under certain conditions. The thermal design of the shunt regulator, manipulator, portable light, and emergency brake device is analysed given the characteristics of the demands on manned spacecraft. The use of a thermostat to solve the temperature control problem when a computer is not available is a common feature of these thermal designs. The temperature results of the on-orbit test and ground test prove that using a thermostat in the heater system of spacecraft can ensure equipment is within the range of index requirement reliably.

No abstract

No abstract

No abstract

No abstract

Space manipulators have attracted much attention due to their implications in on-orbit servicing in recent years. Air bearing based support equipment is widely used for ground test to offset the effect of gravity. However, an air bearing support introduces a new problem caused by additional inertial and mass properties. Additional mass and inertial load will influence the dynamics behavior, especially stiffness information and vibration response of the whole ground test system. In this paper, a set of procedures are presented to remove the influence of air bearings and identify the true equivalent joint stiffness and damping from the test data of a motor-braked space manipulator with an air bearing support. First, inertia parameters are identified. Then, the equivalent joint stiffness and damping are determined by using a genetic algorithm (GA) method. Finally, true vibration characteristics of the manipulator are estimated by removing the additional inertia caused by the air bearings. Moreover, simulations and experiments are carried out to validate the presented procedures.