In this work, solar cells with a freshly made CH NH PbI perovskite film showed a power conversion efficiency (PCE) of 15.4 % whereas the one with 50 days aged perovskite film only 6.1 %. However, when the aged perovskite was covered with a layer of Al O deposited by atomic layer deposition (ALD) at room temperature (RT), the PCE value was clearly enhanced. X-ray photoelectron spectroscopy study showed that the ALD precursors are chemically active only at the perovskite surface and passivate it. Moreover, the RT-ALD-Al O -covered perovskite films showed enhanced ambient air stability.

Platinum, being the most efficient and stable catalyst, is used in photoelectrochemical (PEC) devices. However, a minimal amount of Pt with maximum catalytic activity is required to be used to minimize the cost of production. In this work, we use an environmentally friendly, cost-effective, and less Pt-consuming method to prepare PEC devices for the hydrogen evolution reaction (HER). The Pt monolayer catalyst is selectively deposited on a Au-nanoisland-supported boron-doped p-type Si (100) photocathode. The PEC device based on the Si photocathode with an ultralow loading of the Pt catalyst exhibits a comparable performance for the HER to that of devices with a thick Pt layer. In addition, we demonstrate that by using a thin TiO 2 layer deposited by atomic layer deposition photo-oxidation of the Si photocathode can be blocked resulting in a stable PEC performance.

A comparative study of thin aluminum nitride (AlN) films deposited by plasma-enhanced atomic layer deposition in the SENTECH SI ALD LL system applying either a direct inductively coupled plasma (ICP) or an indirect capacitively coupled plasma (CCP) source is presented. The films prepared with the ICP source (based on a planar triple spiral antenna) exhibit improved properties concerning the growth rate per cycle, total cycle duration, homogeneity, refractive index, fixed and mobile electrical charges, and residual oxygen content compared to the CCP source, where the comparison is based on the applied plasma power of 200 W. The increase of the plasma power to 600 W in the ICP process significantly reduces the residual oxygen content and enhances the electrical breakdown field. The AlN layers grown under these conditions, with a growth rate per cycle of 1.54 Å/cycle, contain residual oxygen and carbon concentrations of about 10% and 4%, respectively, and possess a refractive index of 2.07 (at 632.8 nm).