No abstract

The effects of a conventional lance tip with 4 normal nozzles and a lance tip with 4 twisted nozzles on slag splashing were investigated. A cold model for LD converters, Jiuquan Iron & Steel Co., was established and the amount of slag splashed onto the model walls was measured in the cold modelling experiments. The results from the experiments show that at low top gas flow rate the amount of slag splashing for the tip with twisted nozzles is less than that for the conventional tip, whereas at high top gas flow rate the amount of slag splashing for the nozzle twisted lance is greater than that for the conventional lance. For the nozzle twisted lance tip, slag splashing rates increase with increase in slag amount, lance height and top gas flow rate and the maximum amount of slag splashing for the tip with twisted nozzles can be obtained under the process parameters of 47.6 Nm 3/h gas flow rate, 12% slag amount and 247 mm lance height. More slag droplets can be directed onto the cone with a nozzle twisted lance tip than with a normal lance tip at high top gas flow rate.

No abstract

The influence of blowing process parameters on bath stirring was investigated in a model of a top-bottom-side blown converter using physical modelling experiments. It was shown that the side blowing gas flowrate has an important influence on bath mixing time which decreases as side tuyere gas flowrate increases up to a critical flowrate and then plateaus. Bottom gas injection is favourable for bath mixing for top-bottom-side blown converters; however, top lance height, top gas flowrate and bath level have little influence.

No abstract