Solar desalination is a promising and sustainable solution for water shortages in the future. Interfacial solar‐to‐heat conversion for desalination has attracted increasing attention in the past decades, due to the heat localization induced high thermal efficiency, simple structure, and low cost. In this review, the authors summarize and analyze the critical processes involved in such a solar desalination system, including the thermal conversion and transport, salt dissipation, and vapor manipulation. Mathematical models of heat transfer and salt dissipation are also built for quantitative analysis of systematic performance relative to properties of employed materials and system designs. Recent efforts devoted to improving the overall thermal efficiency, salt rejection, and water yield are then summarized. Based on the analysis and previous results, opportunities for further interfacial solar desalination development are highlighted.

A novel solid-phase microextraction (SPME) fiber containing hydroxydibenzo-14-crown-4 (OH-DB14C4)/hydroxy-terminated silicone oil (OH-TSO) was first prepared by a sol-gel method and investigated for the determination of phenols. The possible mechanism is discussed and confirmed by IR spectra. The coating has stable performance in high temperature (to 350 degrees C) and solvents (organic and inorganic) due to the chemical binding between the coating and the fiber surface. The addition of crown ether enhances the polarity of the coating compared with that of the sol-gel OH-terminated silicone oil fiber and, accordingly, provides higher extraction efficiency for polar phenolic compounds. On the other hand, OH-terminated silicone oil in the coating can not only increase the length of network but also help to spread the stationary phase on the silica surface uniformly. The fluorescence microscopy experiment suggests the benefit the more uniform surface of the sol-gel-derived OHDB14C4/OH-TSO fiber in comparison with sol-gelderived OH-DB14C4 fiber. Some parameters of the SPME fiber for the determination of phenols were investigated. Limits of detection of the phenols are below 1.0 ng/mL, and the precisions are from 2.9 to 4.6% (n = 6). Linear ranges were found to be 0.1-10 microg/mL The sensitivity of the method is enhanced at a low-pH level (pH approximately 1) and with the addition of salt. The method was applied to the analysis of wastewater sample from a paper mill.

No abstract

No abstract