This paper presents measurements of strength of textile products with thermography monitoring. Temperature and load during elongation up to break are measured for various materials, such as yarns, woven or knitted fabrics. A correlation has been found between the temperature at the place of break and elongation and tensile strength.

The article describes the construction and testing of a functional model of an innovative warp – knitting machine for technical spatial knitted fabrics with an original structure. Design assumptions regarding the geometrical, kinematic and driving characteristics of the machine are described. The functional model as well as its physical implementation as a research stand are presented. The production phases of the 3D knitted fabric are also demonstrated. The research results are described and their importance for the construction of a machine prototype of the production version are emphasised.

The assumptions of instrumental methodology for measuring dynamic loads of knitted barrier meshes were defined. A test stand was built, original in terms of both mechanical construction and electronic measuring system, connected to a computer data analysis system. Maximum values of dynamic forces in the mesh fastening strings were determined. The correctness of the strain gauges construction and measurement data transmission systems was confirmed. Tests of multidirectional resistance to dynamic loads in the mesh fastening strings were carried out. The experiment involved dropping a ball with a mass of 5 kg and a diameter of 10 cm, from a height of 1 m and 2 m onto the mesh surface. The potential impact energy equaled Ep1 = 49.05 J and Ep2 = 98.1 J. The tests showed that the highest force values were observed for meshes with square-shaped a-jour structure, and for mesh with diamond-shaped a-jour geometry the force values were lower. A symmetrical forces distribution was observed in all the strings. The highest forces were recorded in the middle strings and the lowest in the outer ones. The conducted tests confirmed the correctness of the adopted constructional solutions of test stand for identification of dynamic stress distribution in mesh fastening strings. The developed method is a useful verification tool for numerical analysis of mechanical properties of barrier meshes.

The first part of the publication presents a substantively insightful literature study on the essence and effects of light waves on wound healing in living organisms, including the use of phototherapy in the treatment of the diabetic foot. A knitted textile dressing was designed and manufactured for phototherapy of patients with diabetes suffering from diabetic foot syndrome (DFS). The proposed solution is intended for the treatment of dermal tissues within the patient's foot affected because of diabetic disease at an early stage. Thus, the use of a knitted dressing with incorporated fiber optic structures and powered by a semiconductor laser emitting a 405 nm light wave from its entire surface would prevent further anomalies of the patient's tissues and help to avoid surgical intervention.

Material selection is an important stage in the design of footwear, which determines not only its appearance, but also the comfort of use. The paper presents the methodology for the design of sports textile footwear manufactured by innovative hybrid technology. The upper part of the footwear, designed in CAD and a graphics program, consisted of two elements. Both of them were characterized by a three-layer knitted and embroidered structure. The air permeability and thermal insulation parameters were determined for each layer and for the whole package. The conducted tests demonstrated that the openwork spacer knitted fabric, as a component of the package, increased the air circulation inside the footwear as well as improved the heat transfer outside.