No abstract

Prediction of void occurrence during capillary underfill encapsulation process is vital to avoid package failure due to incomplete filling during the encapsulation process. Two design variables, namely the gap height and package orientations, together with different types of industrial standard design of dispensing methods were identified as possible influences to the void formation in encapsulated package. In this paper, all these factors have been closely related to the void formation and subsequently the best chip design has been formulated to improve package reliability. From the study, air entrapment is clearly visualized in the experiment, which can be detrimental as it contains trapped oxygen, which can combust at high temperature. A series of experiments eventually showed higher possibility of air void formation by U-type dispensing method compared with the L-type dispensing method. In addition, it is found that the chip design parameters that include the scaling size and ball grid array orientation have an effect on the size of void formed. Our experimental findings were validated using lattice-Boltzmann method simulation and great consensus is found between both approaches. These findings provide additional insights to the electronic packaging developer to effectively reduce the formation of void during encapsulation process.

This paper studies the three dimensional (3D) simulation of fluid flows through the ball grid array (BGA) to replicate the real underfill encapsulation process. The effect of different solder bump arrangements of BGA on the flow front, pressure and velocity of the fluid is investigated. The flow front, pressure and velocity for different time intervals are determined and analyzed for potential problems relating to solder bump damage. The simulation results from Lattice Boltzmann Method (LBM) code will be validated with experimental findings as well as the conventional Finite Volume Method (FVM) code to ensure highly accurate simulation setup. Based on the findings, good agreement can be seen between LBM and FVM simulations as well as the experimental observations. It was shown that only LBM is capable of capturing the micro-voids formation. This study also shows an increasing trend in fluid filling time for BGA with perimeter, middle empty and full orientations. The perimeter orientation has a higher pressure fluid at the middle region of BGA surface compared to middle empty and full orientation. This research would shed new light for a highly accurate simulation of encapsulation process using LBM and help to further increase the reliability of the package produced.

No abstract

Purpose In line with the recent development of flip-chip reliability and underfill process, this paper aims to comprehensively investigate the effect of different hourglass shape solder joint on underfill encapsulation process by mean of experimental and numerical method. Design/methodology/approach Lattice Boltzmann method (LBM) numerical was used for the three-dimensional simulation of underfill process. The effects of ball grid arrays (BGA) encapsulation process in terms of filling time of the fluid were investigated. Experiments were then carried out to validate the simulation results. Findings Hourglass shape solder joint has shown the shortest filling time for underfill process compared to truncated sphere. The underfill flow obtained from both simulation and experimental results are found to be in good agreement for the BGA model studied. The findings have also shown that the filling time of Hourglass 2 with parabolic shape gives faster filling time compared to the Hourglass 1 with hemisphere angle due to bigger cross-sectional area of void between the solder joints. Practical implications This paper provides reliable insights to the effect of hourglass shape BGA on the encapsulation process that will benefit future development of BGA packages. Originality/value LBM numerical method was implemented in this research to study the flow behaviour of an encapsulation process in term of filling time of hourglass shape BGA. To date, no research has been found to simulate the hourglass shape BGA using LBM.