Graphite fluoride (CF x ) cathodes coupled with lithium anodes yield one of the highest theoretical specific capacities (>860 mAh/g) among primary batteries. In practice, the observed discharge voltage (∼2.5 V) is significantly lower than thermodynamic limits (>4.5 V), the discharge rate is low, and so far Li/CF x has only been used in primary batteries. Understanding the discharge mechanism at atomic length scales will improve practical CF x energy density, rate capability, and rechargeability. So far, purely experimental techniques have not identified the correct discharge mechanism or explained the discharge voltage. We apply density functional theory calculations to demonstrate that a CF x -edge propagation discharge mechanism based on lithium insertion at the CF/C boundary in partially discharged CF x exhibits a voltage range of 2.5 to 2.9 Vdepending on whether solvent molecules are involved. The voltages and solvent dependence agree with our discharge and galvanostatic intermittent titration technique measurements. The predicted discharge kinetics are consistent with CF x operations. Finally, we predict some Li/CF x rechargeability under the application of high potentials, along a charging pathway different from that of discharge. Our work represents a general, quasi-kinetic framework to understand the discharge of conversion cathodes, circumventing the widely used phase diagram approach which most likely does not apply to Li/CF x because equilibrium conditions are not attained in this system.
Electrocatalytic synthesis of high value-added urea and ethanol from carbon dioxide (CO2) and nitric oxide (NO) via C−N and C−C coupling reactions is one of the most attractive approaches. Nevertheless,...
Electrocatalytic CO2 reduction (CO2RR) is a feasible and economical way to eliminate CO2 by converting it into useful products. However, this process is hampered by the lack of a highly...
The electrochemical carbon dioxide reduction reaction
(CO2RR) has been extensively studied due to its potential
to reduce the
globally accelerating CO2 emission and produce value-added
chemicals and fuels. Despite great efforts to optimize the catalyst
activity and selectivity, the development of robust design criteria
for screening the catalysts and understanding the role of water and
potassium for CO2 activation poses a significant challenge.
Herein, a rapid method for screening single-atom catalysts (SACs)
possessing different coordination structures toward the CO2RR process to form CO, namely, a metal atom supported on nitrogen-doped
carbon nanotubes (M@CNT, M@1N_CNT, M@2N_CNT, and M@3N_CNT), was established
using large-scale density functional theory computations. Adopting
the free energy of *CO2 and *OH as screening descriptors,
Fe@CNT, Cu@1N_CNT, Pd@2N_CNT, and Ni@3N_CNT were found to exhibit
high activity for CO in the gas phase with the overpotential values
of 0.22, 0.11, 0.13, and 0.05 V, respectively. Water and potassium
present on the surface of the active sites can accelerate the activation
of CO2 relative to the gas phase. Ni@3N_CNT shows the highest
activity and selectivity in the environment having four water and
one potassium. Particularly, the least absolute shrinkage and selection
operator regression study revealed that the CO2 adsorption
is intrinsically governed by the number of electrons lost by the metal
atom in the three N-doped systems, which can be correlated to the
distance of the metal atom from the plane of the coordination atom
in the M@CNT system. Besides, the study proposes equations for the
calculation of the free energy of CO2 adsorption. The current
work not only advances the exploration of highly active SACs for the
heterogeneous electrocatalytic systems for CO2RR but also
highlights the significance of water and potassium in the aqueous
solution.
Excess of carbon dioxide (CO2) in the atmosphere poses a significant threat to the global climate. Therefore, the electrocatalytic carbon dioxide reduction reaction (CO2RR) is important to reduce the burden on the environment and provide possibilities for developing new energy sources. However, highly active and selective catalysts are needed to effectively catalyze product synthesis with high adhesion value. Single-atom catalysts (SACs) and double-atom catalysts (DACs) have attracted much attention in the field of electrocatalysis due to their high activity, strong selectivity, and high atomic utilization. This review summarized the research progress of electrocatalytic CO2RR related to different types of SACs and DACs. The emphasis was laid on the catalytic reaction mechanism of SACs and DACs using the theoretical calculation method. Furthermore, the influences of solvation and electrode potential were studied to simulate the real electrochemical environment to bridge the gap between experiments and computations. Finally, the current challenges and future development prospects were summarized and prospected for CO2RR to lay the foundation for the theoretical research of SACs and DACs in other aspects.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.