No abstract

Geothermal energy potential in China is high, and although they currently lead the way in direct heat production, geothermal power generation is still low. Hot spring analysis and surface heat flux data indicate significant potential resources for the major industrial province of Guangdong, South China. This pilot study investigates the Heyuan Fault, Guangdong, as a potential site for a geothermal power plant. Here we line out (i) preferred locations of possible hot spots on fault intersections, (ii) the possible sources of the heat anomalies, (iii) potential pathways for hot fluid circulation in the upper crust, (iv) available hot spring data and (v) the future work plan to investigate the geothermal hot spots. We find that hot springs occur along the NE trending Heyuan Fault, clustering where NNW striking faults crosscut the Heyuan. The increased heat flow can be explained partly by radioactive decay of a large granite pluton beneath the fault, however, additional heat sources may need to be considered to explain the heat flow maxima of above 85 mWm-2. We postulate that advective (topographically driven) and convective (deep fluids ponding at the brittle-ductile transition) processes may be operating to generate these heat anomalies. Expansive quartz reef systems exposed on the Heyuan Fault, are proposed here, to represent uplifted sections of these deep fluid circulation patterns. A detailed systematic analysis of reef structures will reveal (i) the fluid provenance, (ii) precipitation conditions and (iii) deformation mechanisms, which will ultimately help us understand how fault intersection relations control fluid flow; which is of key significance if it can be utilised for targeting geothermal energy.

No abstract

Thermal history of the Sichuan basin is reconstructed based on vitrinite reflectance from boreholes in the basin using a paleo-heat flow method. The results show that the Sichuan basin experienced a relatively low heat flow period in the Early Paleozoic，and an elevated paleo-heat flow, ranging 60−80 mW/m 2 with a maximum as high as 100 mW/m 2 around 259 Ma, from the beginning of the Late Paleozoic to the end of the early Permian, and a decreased paleo-heat flow from the late Permian to the late Triassic, and then maintained nearly stable to the present. The Late Paleozoic paleo-heat flow was quite high where there were extensive Emeishan flood basalts or concealed basalts which erupted between the early and the late Permian, such as the southwestern and northeastern areas of the Sichuan basin. According to the distribution of paleo-heat flow, it can be inferred that, the northeastern Sichuan basin was also influenced by the Emeishan magmatic activity during the Dongwu movement though there was lack of Emeishan flood basalts. In addition, the results of thermal history reconstruction of the Sichuan basin provide paleogeothermal evidence for the existence and onset of the Emaishan mantle plume. vitrinite reflectance, paleo-heat flow method, thermal history, Emeishan mantle plume, Sichuan basin Citation: Zhu C Q, Xu M, Yuan Y S, et al. Palaeogeothermal response and record of the effusing of Emeishan basalts in the Sichuan basin. Chinese Sci Bull, 2010, 55: 949−956,

The palaeotemperature recorded by vitrinite reflectance (Ro) in the pre-Cenozoic uplifted stratigraphic strata, and in Palaeozoic–Mesozoic remnant basins outside the Cenozoic depocentres, has not been overprinted by later thermal events in the eastern North China Craton (NCC). Based on downhole Ro data from the Palaeozoic and the Mesozoic subsections, we reconstruct the temperature gradients when the subsections reached their maximum palaeotemperatures in the Middle Triassic and the Cretaceous, and calculate the corresponding heat flow histories since the early Mesozoic. The temperature gradient and heat flow were much higher in the Cretaceous (35–43 °C km−1 and 73–83 mW m−2, respectively) than in the Middle Triassic and at the present. The high palaeo-heat flow during the Late Mesozoic implies that the thickness of the ‘thermal’ lithosphere at that time was c. 65 km, about half the thickness of c. 135 km estimated for the Early Mesozoic. The change from a stable thermal regime to an active thermal regime took place during the Late Jurassic–Early Cretaceous (c. 110 Ma). This tectonothermal event was accompanied by extensive surface erosion, and is also evidenced in the areas adjacent to the NCC, such as the South Yellow Sea and East China Sea basins. Our study provides not only geothermal evidence for the Late Mesozoic lithospheric thinning, but also additional constraints on the thinning mechanism, which is currently being debated.

No abstract

[1] The Chinese Continental Scientific Drilling (CCSD) Project offers a unique opportunity for studying the thermal regime of the Dabie-Sulu ultrahigh-pressure metamorphic belt. In this paper, we report measurements of borehole temperature, thermal conductivity, and radiogenic heat production from the 5158 m deep main hole (CCSD MH). We have obtained six continuous temperature profiles from this borehole so far. The temperature logs show a transient mean thermal gradient that has increased from 24.38 to 25.28 K km À1 over a period of about 1.5 years. We measured thermal conductivities and radiogenic heat productions on more than 400 core samples from CCSD MH. The measured thermal conductivities range between 1.71 and 3.60 W m À1 K À1 , and the radiogenic heat productions vary from 0.01 mW m À3 to over 5.0 mW m À3 , with a mean value of 1.23 ± 0.82 mW m À3 for the upper 5-km layer of the crust. The heat productions in CCSD MH appear to be more rock-type than depth-dependent and, over the depth range of CCSD MH, do not fit the popular model of heat production decreasing exponentially with increasing depth. The measured heat flow decreases with depth from $75 mW m À2 near the surface to $66 mW m À2 at a depth of 4600 m. High heat flow anomalies occur at $1000 and $2300 m, and low anomalies occur at 3300-4000 m. A preliminary two-dimensional numerical model suggests that both radiogenic heat production and thermal refraction due to structural heterogeneity are at least partially responsible for the vertical variation of heat flow in CCSD MH.

A distinctive NNE trending belt of shortening structures dominates the topography and deformation of the eastern Sichuan Basin, ~300 km east of the Tibetan Plateau. Debate continues as to whether the structures resulted from Cenozoic eastward growth of the Tibetan Plateau. A low‐temperature thermochronology (AFT and AHe) data set from four deep boreholes and adjacent outcrops intersecting a branch of the shortening structures indicates distinctive differential cooling at ~35–28 Ma across the structure, where stratigraphy has been offset vertically by ~0.8–1.3 km. This result forms the first quantitative evidence for the existence of a late Eocene‐Oligocene phase of shortening in the eastern Sichuan Basin, synchronous with the early phase of eastward growth and extrusion of the Tibetan Plateau. Further, a compilation of regional Cenozoic structures reveals a Miocene retreat of deformation from the foreland basin to the hinterland areas. Such a tectonic reorganization indicates that Eocene to Miocene deformation in the eastern Tibetan Plateau is out‐of‐sequence and was probably triggered by enhanced erosion in the eastern Tibetan Plateau.