Atomic force microscopy (AFM) has proven to be a valuable instrument to characterize quantitatively the mechanical and morphological properties of soft materials. For medium and hard samples (E41 MPa), the nanomechanical accuracy of AFM is well established and ascertained. However, for soft samples, the experimental setup and data analysis for AFM are not yet firmly established. A calibration obtained for homogeneous samples with a Young's modulus ranging from 100 Pa to a few kPa will prove its usefulness for nanomechanical AFM investigations of soft biological specimens, such as living cells and extracellular matrices. For this purpose, poly(N-isopropylacrylamide) (PNIPAM) hydrogels were synthesized in different methanol − water mixtures to produce a series of homogeneous samples with finely tunable mechanical properties. These samples allowed the comparison and validation of AFM force spectroscopy results using macroscopic and rheological techniques. In AFM measurements, the geometry of the indenter is fundamental to the model used for data interpretation; therefore, experiments were carried out using spherical micrometric and standard pyramidal sharp probes. Moreover, a PNIPAM gel embedded with hard microspheres was analyzed, which showed the capability of AFM for measuring the local mechanical properties of heterogeneous samples.

We continue to investigate the design, synthesis, and characterization of electrically and ionically active conjugated polythiophene copolymers for integrating a variety of biomedical devices with living tissue. This paper will describe some of our most recent results, including the development of several new monomers that can tailor the surface chemistry, adhesion, and biointegration of these materials with neural cells. Our efforts have focused on copolymers of 3,4 ethylenedioxythiophene (EDOT), functionalized variants of EDOT (including EDOT-acid and the trifunctional EPh), and dopamine (DOPA). The resulting PEDOT-based copolymers have electrical, optical, mechanical, and adhesive properties that can be precisely tailored by fine tuning the chemical composition and structure. Here we present results on EDOT-dopamine bifunctional monomers and their corresponding polymers. We discuss the design and synthesis of an EDOT-cholesterol that combines the thiophene with a biological moiety known to exhibit surface-active behaviour. We will also introduce EDOT-aldehyde and EDOT-maleimide monomers and show how they can be used as the starting point for a wide variety of functionalized monomers and polymers.

The commercially available polyelectrolyte complex poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) is ubiquitous in organic and hybrid electronics. As such, it has often been used as a benchmark material for fundamental studies and...

No abstract

No abstract

Random copolymer gels of N-isopropylacrylamide (NIPAM) and N-ethylacrylamide (NEAM) were synthesized using 1 : 1 monomer molar ratio in different methanol–water mixtures. (xm = 0, 0.06, 0.13, 0.21, 0.31 0.43, 0.57, 0.76, where xm = mole fraction of methanol) (xm = 0, 0.06, 0.13, 0.21, 0.31, 0.43, 0.57, 0.76, where xm = mole fraction of methanol).

No abstract

Here we examined the capacitive behavior of electrodeposited poly(2’-maleimideomethyl-3,4-ethylenedioxythiophene) (PEDOT-maleimide) and compared it to poly(3,4-ethylenedioxythiophene) (PEDOT). According to results of linear cyclic voltammetry (linear CV) and galvanostatic charging/discharging (GCD) in...