There is a special circumfluence in the center region of cross-section for a tri-screw extruder. To study the effect of the dynamic center region on the flow and mixing mechanism of the tri-screw extruder, 2D finite element modeling was used to reduce the axial effects. Based on the particle tracking technology, the nonlinear dynamics of a typical particle motions in the center region was carried out and the mixing process in the tri-screw extruder was analyzed with Poincaré maps. Moreover, mixing evaluations of the tri-screw and twin-screw extruders were analyzed and compared. The results show that there are many multiple and fractional excitation frequencies in the Fast Fourier Transform (FFT) spectrums, and it shows a chaotic motion in the center region. Poincaré section maps in the tri-screw show the better particles diffusive ability than those in the twin-screw extrude due to the excellent diffluent ability. Furthermore, the tri-screw extruder has the better dispersive, distributive mixing abilities and stretching mixing efficiency than the twin-screw extruder in the cross-section.
The mixing characteristics of two initially stratified high‐viscosity fluids with a free surface under forced vertical vibration were studied experimentally and numerically. The flow characteristics and dynamics of the free surface and interface between liquids were analyzed and the effects of the vibration parameters on the mixing process were evaluated. The degree of mixing was determined by the frequency and amplitude of vibration. Effective mixing could not be achieved by merely using the deformation of the free surface because of the low fluidity of high‐viscosity fluids. However, an increase in vibration intensity disintegrated the free surface and interface, thereby significantly promoting the mixing of fluids and improving the mixing efficiency.
Three-dimensional finite element modeling of polymer melt flowing in a new co-rotating tri-screw extruder was established with mesh superposition technique. Based on the particle tracking technology, three typical particle trajectories in the tri-screw extruder were calculated using a 4th-order-Runge-Kutta method to study the dynamic motions of the particles. Then the flow visualizations in the local center region were carried out. Moreover, the dispersive, distributive and stretching mixing efficiencies of the tri-screw and twin-screw extruders were compared, respectively. The results show that when the particles move from one screw to another, there are great abrupt changes in the velocities and displacements, which induce the abrupt change in the stress magnitude. Most of particles, which are initially distributed in the inlet plane of the center region, fast flow out the outlet and don't pass through any screw. This special phenomenon induces a series of new characteristics in the residence time distribution (RTD), flow number, segregation scale and time averaged efficiency. In comparison with the twin-screw extruder, the tri-screw extruder has better mixing efficiency.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.