No abstract

A detailed chemistry-based CFD model was developed to simulate the diesel spray combustion and emission process. A reaction mechanism of n-heptane is coupled with a reduced NOx mechanism to simulate diesel fuel oxidation and NOx formation. The soot emission process is simulated by a phenomenological soot model that uses a competing formation and oxidation rate formulation. The model is applied to predict the diesel spray lift-off length and its sooting tendency under high temperature and pressure conditions with good agreement with experiments of Sandia. Various nozzle diameters and chamber conditions were investigated. The model successfully predicts that the sooting tendency is reduced as the nozzle diameter is reduced and/or the initial chamber gas temperature is decreased, as observed by the experiments. The model is also applied to simulate diesel engine combustion under premixed charge compression ignition (PCCI) conditions. Trends of heat release rate, NOx, and soot emissions with respect to EGR levels and start-of-injection timings are also well predicted. Both experiments and models reveal that soot emissions peak when the start of injection (SOI) occurs close to TDC. The model indicates that low soot emission at early SOI is due to better oxidation while low soot emission at late SOI is due to less formation. Since NOx emissions decrease monotonically with injection retardation, a late injection scheme can be utilized for simultaneous soot and NOx reduction for the engine conditions investigated in this study.

A detailed chemistry-based CFD model was developed to simulate the diesel spray combustion and emission process. A reaction mechanism of n-heptane is coupled with a reduced NOx mechanism to simulate diesel fuel oxidation and NOx formation. The soot emission process is simulated by a phenomenological soot model that uses a competing formation and oxidation rate formulation. The model is applied to predict the diesel spray lift-off length and its sooting tendency under high temperature and pressure conditions with good agreement with experiments of Sandia. Various nozzle diameters and chamber conditions were investigated. The model successfully predicts that the sooting tendency is reduced as the nozzle diameter is reduced and/or the initial chamber gas temperature is decreased, as observed by the experiments. The model is also applied to simulate diesel engine combustion under PCCI-like conditions. Trends of heat release rate, NOx and soot emissions with respect to EGR levels and start-of-injection timings are also well predicted. Both experiments and models reveal that soot emissions peak when the start of injection occurs close to TDC. The model indicates that low soot emission at early SOI is due to better oxidation while low soot emission at late SOI is due to less formation. Since NOx emissions decrease monotonically with injection retardation, a late injection scheme can be utilized for simultaneous soot and NOx reduction for the engine conditions investigated in this study.

No abstract

No abstract

In order to meet future emissions regulations, new combustion concepts are being developed. Among them, the development of low-temperature diesel combustion systems has received considerable attention. Low NOx emissions are achieved through minimization of peak temperatures occurring during the combustion process. Concurrently, soot formation is inhibited due to a combination of low combustion temperatures and extensive fuel-air pre-mixing. In this study, the effect of late-cycle mixing enhancement by post injection strategies on combustion and engine-out emissions in the low-temperature combustion regime was investigated experimentally and numerically. The baseline operating condition considered for low-temperature combustion was 1500 rev/min, 3bar IMEP with 50% EGR rate, and extension to high loads was considered by means of post injection. Post injection strategies gave very favorable emission results in the low temperature combustion regime at all loads. With small second fuel injected amounts, better soot emissions were found. However, the determination of the dwell between the injections was found to be very important for the emissions. Since post injection leads to late-cycle mixing improvement, further reductions in soot emissions were achieved without deteriorating the NOx emissions. To explain these results, numerical analysis was also done using the KIVA-CHEMKIN code. The simulations show that optimal combustion requires that the post injection fuel avoid fuel rich regions formed from the main injection.

No abstract

No abstract