Low-cost anion exchange membrane fuel cells have been investigated as a promising alternative to proton exchange membrane fuel cells for the last decade. The major barriers to the viability of anion exchange membrane fuel cells are their unsatisfactory key components—anion exchange ionomers and membranes. Here, we present a series of durable poly(fluorenyl aryl piperidinium) ionomers and membranes where the membranes possess high OH− conductivity of 208 mS cm−1 at 80 °C, low H2 permeability, excellent mechanical properties (84.5 MPa TS), and 2000 h ex-situ durability in 1 M NaOH at 80 °C, while the ionomers have high water vapor permeability and low phenyl adsorption. Based on our rational design of poly(fluorenyl aryl piperidinium) membranes and ionomers, we demonstrate alkaline fuel cell performances of 2.34 W cm−2 in H2-O2 and 1.25 W cm−2 in H2-air (CO2-free) at 80 °C. The present cells can be operated stably under a 0.2 A cm−2 current density for ~200 h.

Titanium dioxide (TiO(2)) is one of the most promising anode materials for lithium ion batteries due to low cost and structural stability during Li insertion/extraction. However, its poor rate capability limits its practical use. Although various approaches have been explored to overcome this problem, previous reports have mainly focused on the enhancement of both the electronic conductivity and the kinetic associated with lithium in the composite film of active material/conducting agent/binder. Here, we systematically explore the effect of the contact resistance between a current collector and a composite film of active material/conducting agent/binder on the rate capability of a TiO(2)-based electrode. The vertically aligned TiO(2) nanotubes arrays, directly grown on the current collector, with sealed cap and unsealed cap, and conventional randomly oriented TiO(2) nanotubes electrodes were prepared for this study. The vertically aligned TiO(2) nanotubes array electrode with unsealed cap showed superior performance with six times higher capacity at 10 C rate compared to conventional randomly oriented TiO(2) nanotubes electrode with 10 wt % conducting agent. On the basis of the detailed experimental results and associated theoretical analysis, we demonstrate that the reduction of the contact resistance between electrode and current collector plays an important role in improving the electronic conductivity of the overall electrode system.

In the present work, type I, II, and III heterostructures are constructed with the same base material using three representative functionalized monolayer scandium carbides (Sc2CF2, Sc2C(OH)2, and Sc2CO2) by first-principles calculations based on density functional theory. In contrast to general bilayer heterosystems composed of two-dimensional semiconductors, type I and III heterojunctions are obtained in one Sc2CF2/Sc2CO2 system and the remains of the functionalized Sc2C heterostructures, respectively. It is noteworthy that the same monolayer Sc2CF2 and Sc2CO2 constituents lead to dissimilar heterostructure types in the two Sc2CF2/Sc2CO2 systems by modifying the stacking interface. In addition, in the two Sc2CF2/Sc2CO2 systems, remarkable changes in the heterojunction type are induced by a strain, and two distinct type-II heterostructures are generated where one layer with the conduction band minimum state and the other layer including the valence band maximum level are different. The present work suggests an attractive direction to obtain all heterostructure types with the same base material for novel nanodevices in various fields such as photonics, electronics, and optoelectronics using only the two monolayer components Sc2CF2 and Sc2CO2.

No abstract