Weight reduction of Unmanned Aerial Vehicle (UAV) components and systems is one of the most essential factors for aviation. Takeoff gross weight can be divided into crew weight, payload, fuel, and empty weight. The empty weight is divided into the structure, engine/s, landing gear, avionics and fixed equipment. Engine/s, landing gear, avionics and fixed equipment are selective items. Weight optimization can be made for structure and landing gear to minimize aircraft total weight. The main objective of the present study is to optimize weight and reach safe landing for a medium range UAV landing gear. The reduced weight can be used to increase payload and/or fuel to increase range or endurance of the UAV. In the present study, ANSYS shape (Topology) optimization tool is used to get a proposed shape for the UAV landing gear. Then parametric size optimization of the shape proposed was done. Design of experiment (DOE) technique is used in order to get the minimum weight for the landing gear at a specified stress limit. Aluminum alloy 7075-T61 and bi-directional carbon fiber which are the most common used materials in UAVs landing gear were used, It was found that using topology weight optimization technique reduces Aluminum Alloy landing gear weight by (30.4 %) changing the material to be bi-directional carbon fiber without optimization reduce landing gear weight with additional value (27.9 %). Optimizing bi-directional carbon fiber landing gear reduces the weight with additional value (4 %) to be the total weight ratio by (62.3 %). The optimization technique for weight optimization is a guide to optimize any other type of landing / part to minimize the total weight for the Unmanned Aerial Vehicle.
Abstract. Hybrid sol-gel processing of inorganic-organic nanocomposites has been of a great interest over the last decades for being advantageous compared to the conventional addition methods of nanoparticles. In this study, a three-component system was adopted experiencing the design and preparation of different hybrid ceramic coatings based on Diglycidyl ether of Bisphenol A (Epoxy) and 3-Glycidyloxypropyl trimethyloxysilane (GLYMO) by sol-gel technique. The obtained hybrid coatings were cured using different hardeners, Diethylene triamine (DETA) as an organic linker and 3-Aminopropyl triethoxysilane (APTES) as an inorganic/organic linker. Microstructure assessment and the morphology of the prepared hybrids was investigated using FTIR and scanning electron microscopy (SEM) respectively. Mechanical properties (adhesion, and hardness) were determined. The degree of hydrophilicity of the hybrids was assigned depending on the contact angle measurements. Moreover, the thermal properties were investigated using thermogravimetric analysis (TGA). The results showed that the silica content plays an important role in determining the morphology as well as the mechanical, physical, and thermal properties of the coatings. The results showed an improvement in most of the properties of the hybrid coatings with increasing the silica content up to a certain extent. However, further increase in the silica content, leads to a clear deterioration.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.