With the rapid development of energy storage devices, aqueous battery with noncombustion properties and instinct safe features has received great attentions and Zn anode is investigated intensively due to its high theoretical capacity (820 mAh g−1), and low negative potential (−0.762 V vs SHE). However, the unavoidable gas evolution hinders the cyclability and the application in the commercial field. Herein, the atomic layer deposition of TiO2 coating is first demonstrated as the protection layer of metallic zinc anode. The corrosion of zinc plate is significantly suppressed, leading to less gas evolution and Zn(OH)2 byproduct formation. The reduced gas generation on the outer surface of the zinc plate will maintain the effective contact area between the electrolyte and anode and leads to an improved coulombic efficiency. In this way, the Zn anode with 100 ALD cycles TiO2 protection shows reduced overpotential (72.5 mV) at 1 mA cm−2 for Zn–Zn symmetrical battery and additionally, the protection of TiO2 extended the Zn–MnO2 battery cycling performance up to 1000 cycles with the capacity retention of 85% at current density of 3 mA cm−2. The novel design of atomic layer deposition protected metal zinc anode brings in new opportunities to the realization of the ultrasafe aqueous zinc metal batteries.
Zanubrutinib is a potent and highly selective inhibitor of Bruton tyrosine kinase (BTK). In this first-in-human, open-label, multicenter, phase 1 study, patients in part 1 (3 + 3 dose escalation) had relapsed/refractory B-cell malignancies and received zanubrutinib 40, 80, 160, or 320 mg once daily or 160 mg twice daily. Part 2 (expansion) consisted of disease-specific cohorts, including treatment-naive or relapsed/refractory chronic lymphocytic leukemia/small lymphocytic lymphoma (CLL/SLL). The primary end points were safety and tolerability, and definition of the maximum tolerated dose (part 1). Additional end points included pharmacokinetics/pharmacodynamics and preliminary efficacy. Reported herein are results from 144 patients enrolled in the dose-finding and CLL/SLL cohorts. No dose-limiting toxicities occurred in dose escalation. Median BTK occupancy in peripheral blood mononuclear cells was >95% at all doses. Sustained complete (>95%) BTK occupancy in lymph node biopsy specimens was more frequent with 160 mg twice daily than 320 mg once daily (89% vs 50%; P = .0342). Consequently, 160 mg twice daily was selected for further investigation. With median follow-up of 13.7 months (range, 0.4-30.5 months), 89 CLL/SLL patients (94.7%) remain on study. Most toxicities were grade 1/2; neutropenia was the only grade 3/4 toxicity observed in >2 patients. One patient experienced a grade 3 subcutaneous hemorrhage. Among 78 efficacy-evaluable CLL/SLL patients, the overall response rate was 96.2% (95% confidence interval, 89.2-99.2). Estimated progression-free survival at 12 months was 100%. Zanubrutinib demonstrated encouraging activity in CLL/SLL patients, with a low incidence of major toxicities. This trial was registered at www.clinicaltrials.gov as #NCT02343120.
Aqueous rechargeable zinc ion batteries are considered a promising candidate for large‐scale energy storage owing to their low cost and high safety nature. A composite material comprised of H2V3O8 nanowires (NWs) wrapped by graphene sheets and used as the cathode material for aqueous rechargeable zinc ion batteries is developed. Owing to the synergistic merits of desirable structural features of H2V3O8 NWs and high conductivity of the graphene network, the H2V3O8 NW/graphene composite exhibits superior zinc ion storage performance including high capacity of 394 mA h g−1 at 1/3 C, high rate capability of 270 mA h g−1 at 20 C and excellent cycling stability of up to 2000 cycles with a capacity retention of 87%. The battery offers a high energy density of 168 W h kg−1 at 1/3 C and a high power density of 2215 W kg−1 at 20 C (calculated based on the total weight of H2V3O8 NW/graphene composite and the theoretically required amount of Zn). Systematic structural and elemental characterization confirm the reversible Zn2+ and water cointercalation electrochemical reaction mechanism. This work brings a new prospect of designing high‐performance aqueous rechargeable zinc ion batteries for grid‐scale energy storage.
The performances of heterojunction-based electronic devices are extremely sensitive to the interfacial electronic band structure. Here we report a largely enhanced performance of photoelectrochemical (PEC) photoanodes by ferroelectric polarization-endowed band engineering on the basis of TiO2/BaTiO3 core/shell nanowires (NWs). Through a one-step hydrothermal process, a uniform, epitaxial, and spontaneously poled barium titanate (BTO) layer was created on single crystalline TiO2 NWs. Compared to pristine TiO2 NWs, the 5 nm BTO-coated TiO2 NWs achieved 67% photocurrent density enhancement. By numerically calculating the potential distribution across the TiO2/BTO/electrolyte heterojunction and systematically investigating the light absorption, charge injection and separation properties of TiO2 and TiO2/BTO NWs, the PEC performance gain was proved to be a result of the increased charge separation efficiency induced by the ferroelectric polarization of the BTO shell. The ferroelectric polarization could be switched by external electric field poling and yielded PEC performance gain or loss based on the direction of the polarization. This study evidence that the piezotronic effect (ferroelectric or piezoelectric potential-induced band structure engineering) holds great promises in improving the performance of PEC photoelectrodes in addition to chemistry and structure optimization.
Cellulose, the most abundant natural polymer, is renewable, biodegradable, and cost competitive. This paper reports the development of a high‐performance triboelectric nanogenerator (TENG) with both contacting materials made from cellulosic materials. Cellulose nanofibrils (CNFs) are used as the raw material, and chemical reaction approaches are employed to attach nitro groups and methyl groups to cellulose molecules to change the tribopolarities of CNF, which in turn significantly enhances the triboelectric output. Specifically, the nitro‐CNF possesses a negative surface charge density of 85.8 µC m−2, while the methyl‐CNF possesses a positive surface charge density of 62.5 µC m−2, reaching 71% and 52% of that for fluorinated ethylene propylene (FEP), respectively. The figure of merit of the nitro‐CNF and methyl‐CNF is quantified to be 0.504 and 0.267, respectively, comparable to or exceeding a number of common synthetic polymers, such as Kapton, polyvinylidene fluoride, and polyethylene. The TENG fabricated from nitro‐CNF paired with methyl‐CNF demonstrates an average voltage output of 8 V and current output of 9 µA, which approaches the same level obtained from TENG made from FEP. This work demonstrates a successful strategy of using environmentally friendly, abundant cellulosic materials for replacing the synthetic polymers in TENG development.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.