No abstract

AlCl 3 •6H 2 O in a biphasic medium of water/tetrahydrofuran (THF) is effective for the synthesis of 5-hydroxymethylfurfural (HMF) from glucose-based carbohydrates. For glucose, an HMF yield of 61% was achieved in 10 min at 160 • C under microwave heating. The reaction time profile revealed the intermediacy of fructose en route to HMF with a dehydration rate constant that is approximately 4 times that of glucose isomerization to fructose. Addition of NaCl did not increase HMF yields significantly but it diminished lactic acid formation. Disaccharides (maltose and cellobiose) and starch gave good yields of HMF. However, cellulose required a higher temperature (180 • C) and longer reaction time (30 min) to give a modest yield of 37%. Several lignocellulosic biomass variants (corn stover, pine wood, grass, and poplar) were investigated with the AlCl 3 •6H 2 O biphasic system. The yields of HMF were modest (20-35%) but high concurrent yields of furfural were observed (51-66%). The described AlCl 3 •6H 2 O-NaCl-H 2 O/THF biphasic medium has potential because it is economic, nontoxic, and it exhibits fast kinetics (10 min) under microwave heating.

Furfural was prepared in high yields (75 %) from the reaction of xylose in a water-tetrahydrofuran biphasic medium containing AlCl(3)·6H2O and NaCl under microwave heating at 140 °C. The reaction profile revealed the formation of xylulose as an intermediate en route to the dehydration product (furfural). The reaction under these conditions reached completion in 45 min. The aqueous phase containing AlCl(3)·6H(2)O and NaCl could be recycled multiple times (>5) without any loss of activity or selectivity for furfural. Extension of this biphasic reaction system to include xylan as the starting material afforded furfural in 64 % yield. The use of corn stover, pinewood, switchgrass, and poplar gave furfural in 55, 38, 56, and 64 % yield, respectively, at 160 °C. Even though AlCl(3)·6H(2)O did not affect the conversion of crystalline cellulose, moderate yields of the by-product 5-hydroxymethylfurfural (HMF) were noted. The highest HMF yield of 42 % was obtained from pinewood. The coproduction of HMF and furfural from biomass was attributed to the weakening of the cellulose network in the biomass, as a result of hemicellulose hydrolysis. The multifunctional capacity of AlCl(3)·6H(2)O (hemicellulose hydrolysis, xylose isomerization, and xylulose dehydration) in combination with its ease of recyclability make it an attractive candidate/catalyst for the selective synthesis of furfural from various biomass feedstocks.

No abstract

No abstract

No abstract

Cellular structures are promising candidates for additive manufacturing (AM) due to their lower material and energy consumption. In this work, an efficient method is proposed for optimizing the topology of variable-density cellular structures to be fabricated by certain AM process. The method gains accuracy by relating the cellular structure's microstructure to continuous micromechanics models and achieves efficiency through conducting continuum topology optimization at macroscopic scale. The explicit cellular structure is then finally reconstructed by mapping the optimized continuous parameters (e.g., density) to cell structural parameters (e.g., strut diameter). The proposed method is validated by both finite element analysis and experimental tests on specimens manufactured by stereolithography.

No abstract