Nitrite (NO 2 − ) has been extensively applied in agricultural and industrial products and is often found in various foodstuff, tap water, biological samples and environmental systems. However, NO 2 − as a toxic contaminant probably threaten the human health by producing highly carcinogenic N-nitrosamines. Compared with the traditional analytical techniques, electroanalytical method has considerable advantages such as cost-effective, rapidness, facile operation, and easy miniaturization. Graphene nanocomposites have significant synergistic electrocatalytic effect toward the nitrite redox, which could eventually amplify the electrochemical response signals, and improve the selectivity, sensitivity, and practicability for the nitrite detection in various real samples. The recent developments on graphene-based nitrite electrochemical sensors are reviewed from the view of sensing materials, including graphene, metal nanoparticle/graphene composites, nanostructured metal compound/graphene composites, polymer/graphene composites, MOF/graphene composites, enzyme/graphene composites, MWCNT/graphene composites, and electron mediator/graphene composites. Moreover, the sensing performances including detection ranges, limit of detection (LOD) and sensitivity are tabulated. Finally, the major drawbacks, opportunities and challenges of graphene-based nitrite electrochemical sensors are also discussed.

4-nitrophenol (4-NP) is a hazardous waste and a priority toxic pollutant identified by US Environmental Protection Agency (EPA). Hence, in this paper, a voltammetric sensor was proposed for the direct and sensitive detection of 4-nitrophenol (4-NP) at nanomolar level in complex matrices by using graphene and acetylene black paste hybridized electrode (GR/ABPE). Under optimal conditions, the calibration curve demonstrates a linear relationship for 4-NP in the range from 20 nM to 8.0 μM and 8.0 μM to 0.1 mM separately with the detection limit of 8.0 nM. In addition to it, the performance of the GR/ABPE in practical applications was evaluated by detecting 4-NP in various water samples, and satisfactory recoveries were realized. Therefore, GR/ABPE may have a great potential application for facile and sensitive detection of 4-NP in complex matrices at nanomolar level.

No abstract

A method with high sensitivity, good accuracy and fast response is of ever increasing importance for the simultaneous detection of AA, DA and UA. In this paper, a simple and sensitive electrochemical sensor, which based on the polyvinylpyrrolidone (PVP)-graphene composite film modified glassy carbon electrode (PVP-GR/GCE), was presented for detecting ascorbic acid (AA), dopamine (DA) and uric acid (UA) simultaneously. The PVP-GR/GCE has excellent electrocatalytic activity for the oxidation of AA, DA and UA. The second-order derivative linear sweep voltammetry was used for the electrochemical measurements. The peak potential differences of DA-AA, DA-UA, and UA-AA (measured on the PVP-GR/GCE) were 212, 130 and 342 mV respectively. Besides, the over potential of AA, DA and UA reduced obviously, so did the peak current increase. Under the optimum conditions, the linear ranges of AA, DA and UA were 4.0 μM-1.0 mM, 0.02-100 μM, and 0.04-100 μM, respectively. The detection limits were 0.8 μM, 0.002 μM and 0.02 μM for AA, DA, and UA. The electrochemical sensor presented the advantages of high sensitivity and selectivity, excellent reproducibility and long-term stability. Furthermore, the sensor was successfully applied to the analysis of real samples.

A new electrochemical sensor for nanomolar rutin detection based on amine-functionalized Fe3O4 nanoparticles and electrochemically reduced graphene oxide nanocomposite modified glassy carbon electrode (NH2-Fe3O4 NPs-ErGO/GCE) was fabricated through a simple method, and the X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM), transmission electron microscope (TEM), vibrating sample magnetometer (VSM) and electrochemical technique were used to characterize the modified electrode. The electrochemical behavior of rutin on the Fe3O4 NPs-ErGO/GCE was studied in detail. The electrochemical response of rutin at this modified electrode was remarkably higher than that of the bare GCE or other modified GCE (GO/GCE, Fe3O4 NPs-GO/GCE, and ErGO/GCE). Under the optimum determination conditions, Fe3O4 NPs-ErGO/GCE provided rutin with a broader detection range of 6.0 nM–0.1 µM; 0.1–8.0 µM and 8.0–80 µM, a minimum detectable concentration of 4.0 nM was obtained after 210 s accumulation. This novel method was applied in determination of rutin in pharmaceutical tablets and urine samples with satisfactory results.

Objectives. With the rapid development of EEG-based wearable healthcare devices and brain–computer interfaces, reliable and user-friendly EEG sensors for EEG recording, especially at forehead sites, are highly desirable and challenging. However, existing EEG sensors cannot meet the requirements, since wet electrodes require tedious setup and conductive pastes or gels, and most dry electrodes show unacceptable high contact impedance. In addition, the existing electrodes cannot absorb sweat effectively; sweat would cause cross-interferences, and even short circuits, between adjacent electrodes, especially in the moving scenarios, or a hot and humid environment. To resolve these problems, a novel printable flexible Ag/AgCl dry electrode array was developed for EEG acquisition at forehead sites, mainly consisting of screen printing the Ag/AgCl coating, conductive sweat-absorbable sponges and flexible tines. Approach. A systematic method was also established to evaluate the flexible dry electrode array. Main results. The experimental results show the flexible dry electrode array has reproducible electrode potential, relatively low electrode–skin impedance, and good stability. Moreover, the EEG signals can be effectively captured with a high quality that is comparable to that of wet electrodes. Significance. All the results confirmed the feasibility of forehead EEG recording in real-world scenarios using the proposed flexible dry electrode array, with a rapid and facile operation as well as the advantages of self-application, user-friendliness and wearer comfort.

In this paper, a nanocomposite of cuprous oxide and electrochemically reduced graphene oxide (Cu2O–ERGO) was prepared by a simple and low-cost method; hereby, a new method for the electrochemical determination of tryptophan (Trp) by this composite modified glassy carbon electrode (GCE) is proposed. The prepared materials and modified electrodes were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), and cyclic voltammetry (CV). The results showed that Cu2O–ERGO/GCE had good electrocatalytic activity for Trp. The effects of supporting electrolyte, scanning rate, accumulation potential, and accumulation time on the determination of Trp were studied. Under the optimum experimental conditions, Trp was quantitatively analyzed by square-wave voltammetry (SWV). The oxidation peak current of Trp had a good linear relationship with its concentration in the range of 0.02–20 μM, and the detection limit was 0.01 μM (S/N = 3). In addition, the modified electrode has high sensitivity, good repeatability, and long-term stability. Finally, the proposed method has been successfully applied in the determination of Trp concentration in practical samples.

No abstract