We investigated resistance switching in top-electrode/NiO∕Pt structures where the top electrode was Au, Pt, Ti, or Al. For Pt∕NiO∕Pt and Au∕NiO∕Pt structures with ohmic contacts, the effective electric field inside the film was high enough to induce trapping or detrapping at defect states and thus resistance switching. For a Ti∕NiO∕Pt structure with well-defined Schottky contact at Ti∕NiO interface accompanied by an appreciable voltage drop, the effective electric field inside the NiO film was not enough to induce resistance switching. For an Al∕NiO∕Pt structure with a low Schottky barrier at the Al∕NiO interface, resistance switching could be induced at a higher voltage since the voltage drop at the Al∕NiO interface was not negligible but small.

Nano-structured silicon is an attractive alternative anode material to conventional graphite in lithium-ion batteries. However, the anode designs with higher silicon concentrations remain to be commercialized despite recent remarkable progress. One of the most critical issues is the fundamental understanding of the lithium–silicon Coulombic efficiency. Particularly, this is the key to resolve subtle yet accumulatively significant alterations of Coulombic efficiency by various paths of lithium–silicon processes over cycles. Here, we provide quantitative and qualitative insight into how the irreversible behaviors are altered by the processes under amorphous volume changes and hysteretic amorphous–crystalline phase transformations. Repeated latter transformations over cycles, typically featured as a degradation factor, can govern the reversibility behaviors, improving the irreversibility and eventually minimizing cumulative irreversible lithium consumption. This is clearly different from repeated amorphous volume changes with different lithiation depths. The mechanism behind the correlations is elucidated by electrochemical and structural probing.

In this article, the recording physics of a ring head with a single layered perpendicular medium (Ring/SL) is studied and the results are compared with a single pole head with a double layered perpendicular medium (SPT/DL) by using various simulations and experiments. The Ring/SL has much lower effective medium coercivity than the SPT/DL due to the substantial longitudinal field component of ring head and the incoherent rotation mode of medium magnetizations. Furthermore, switching time of the Ring/SL is estimated as only 10%∼30% of the SPT/DL. In the Ring/SL, the head field gradient of 40 Oe/nm is enough for maximizing SNR. The Ring/SL shows very low noise characteristics especially at high linear density. The signal output of the Ring/SL is smaller than the SPT/DL, but it is large enough to be detected. Therefore, it can be concluded that the combination of single layered perpendicular medium and ring head is highly promising for ultrahigh density recording.

According to our new 23 inch CDT's, screen distortion can be reduced without a concave portion as compared with conventional flat-type CDT's in which the central portion of a panel appears to be inwardly curved. A better impact strength can be achieved by making a shadow mask cylindrical curvature horizontal direction. In order to attain high resolution without a focus difference between left and right side beams, a coma compensator is employed, and a rectangular deflection yoke is employed for saving energy.

No abstract