In an atomically thin-film/dielectric-substrate heterostructure, the elemental physical properties of the atomically thin-film are influenced by the interaction between the thin-film and the substrate. In this article, utilizing monolayer MoS(2) on LaAlO(3) and SrTiO(3) substrates, as well as SiO2 and Gel-film as reference substrates similar to previously reported work [Nano Res, 2014, 7, 561], we systematically investigate the substrate effect on the photoluminescence of monolayer MoS(2). We observed significantly substrate-dependant photoluminescence of monolayer MoS(2), originating from substrate-to-film charge transfer. We found that SiO2 substrate introduces the most charge doping while SrTiO(3) introduces less charge transfer. Through the selection of desired substrate, we are able to induce different amounts of charge into the monolayer MoS(2), which consequently modifies the neutral exciton and charged exciton (trion) emissions. Finally, we proposed a band-diagram model to elucidate the relation between charge transfer and the substrate Fermi level and work function. Our work demonstrates that the substrate charge transfer exerts a strong influence on the monolayer MoS(2) photoluminescence property, which should be considered during device design and application. The work also provides a possible route to modify the thin-film photoluminescence property via substrate engineering for future device design.

In this paper, the thermodynamic parameters such as Grüneisen parameters and anharmonicity are investigated utilizing pressure- and temperature-dependent Raman spectroscopy of monolayer transition-metal dichalcogenides MX2 (M = Mo, W; X = S, Se). The result indicates a good stability of these compounds in the pressure range of 0–9.0 GPa and the temperature range of 175–575 K. It is a general trend that Raman mode varies with temperature and pressure linearly for monolayer MX2, and the thermodynamic Grüneisen parameters can be determined from the temperature- and pressure-dependencies of Raman spectra. Based on these measurable parameters, anharmonic parameters are extracted for each active Raman mode. The result shows that the temperature dependencies of the phonon frequencies are well described by considering the contributions from thermal expansion and lattice anharmonicity.

No abstract

No abstract

In situ characterization of phase transitions and direct microscopic observations of a low-melting ionic liquid, 1-butyl-3-methyl imidazolium tetrafluoroborate ([BMIM][BF(4)]), has been performed in detail by Raman spectroscopy. Compression of [BMIM][BF(4)] was measured under hydrostatic pressure up to ~30.0 GPa at room temperature by using a high-pressure diamond anvil cell. With pressure increasing, the characteristic bands of [BMIM][BF(4)] displayed nonmonotonic pressure-induced frequency shifts, and it is found to undergo four successive phase transitions at around 2.25, 6.10, 14.00, and 21.26 GPa. Especially, above a pressure of 21.26 GPa, luminescence of the sample occurs, which is connected with the most significant phase transition at around this pressure. It was indicated that the structure change under high pressure might be associated with a conformational change in the butyl chain. Upon releasing pressure, the spectrum was not recovered under a pressure up to 1.16 GPa, thereby indicating that this high-pressure phase remains stable over a large pressure range between 30 and 1.16 GPa in low-melting ionic liquid [BMIM][BF(4)]. Although the sample was kept under the normal pressure for 24 h, the spectrum was recovered, and it showed that the phase transition of [BMIM][BF(4)] was reversible. In other words, such a low-melting ionic liquid [BMIM][BF(4)] remains stable even after being treated under so a high pressure of up to 30 GPa.

No abstract

No abstract

No abstract