Flame shape and size for a high-pressure turbulent non-premixed swirl combustion were experimentally investigated over a wide range of varying parameters including fuel mass flow rate, combustor pressure, primary-air mass flow rate, and nozzle exit velocity. A CFD simulation was conducted to predict the flame profile. Meanwhile, a theoretical calculation was also performed to estimate flame length. It was observed that flame length increased linearly with increasing fuel mass flow rate but decreased with the increment of combustor pressure in the power function. The flame diminished at a larger primary-air mass flow rate but remained unaffected by the increasing nozzle exit velocity. Considering the global effect of all parameters at a particular pressure, the flame length generally decreased as the primary-air to fuel ratio increased. This was attributed to the reduced air entrainment required to dilute the fuel to stoichiometric proportions. The CFD simulation offered a good prediction of the variation trends of flame length, although some deviations from experimental values were observed. The theoretical calculation estimated the trends of flame length variation particularly well. Nevertheless the difference between the theoretical and experimental results was found to be due to the swirl influence. Hence, a swirl factor was proposed to be added to the original equation for swirl flames.

Flame pulsation has a significant effect on combustion, and understanding its oscillatory behavior is important to the combustion community. An experiment was performed to analyze the pulsation characteristics of a swirl non-premixed flame under various parameters. The results showed that as fuel mass flow rate increased, the puffing frequency increased due to the decreased flame radiation fraction, and the puffing amplitude became smaller resulting in a more stable flame. With an increase in combustor pressure, the flickering frequency declined because of the increasing soot radiation, while the flickering amplitude uniformly increased, leading to more deteriorative flame stability. With an increment in mass flow rate of primary air, the puffing frequency decreased due to the enhanced mixing between fuel and primary air. Also, the puffing amplitude had an oscillating relationship with the mass flow rate of primary air. When the exit velocity of the injector was increased, the flickering frequency diminished nearly linearly because of the improving swirl intensity, and the flickering amplitude was approximately unaffected by injector exit velocity. Moreover, the measured puffing frequencies summarized over all cases varied within the range of 3-22 Hz, the predicted values from theoretical models based on non-swirl flame also fell within this range. The puffing frequency of swirl combustion was more sensitive to the variation in operating conditions than that of non-swirl combustion. Additionally, the obtained correlations indicated that the Strouhal number St was proportional to Fr −1.4 (the Froude number) and Re −2.9 (the Reynolds number), respectively.

No abstract

No abstract

The behavior of the pollutants NO and CO at elevated combustor pressure are of special importance due to the continuing trend toward developing engines operating at higher pressure ratios to yield higher thermal efficiency. An experiment was performed to examine the NO and CO emissions for a swirl convergent-divergent nozzle at elevated pressure. The NO and CO correlations were obtained. Meanwhile, the flame length, exhaust gas oxygen concentration, exit temperature and global flame residence time were also determined to analyze the NO and CO emission characteristics. The results showed that, with the increase in combustor pressure P, flame length decreased proportionally to P −0.49 ; exit O 2 volume fraction increased and exit temperature was reduced. The global flame residence time decreased proportionally to P −0.43. As pressure increased, the NO and Emission Index of NO (EINO) levels decreased proportionally to P −0.53 and P −0.6 respectively, which is mainly attributed to the influence of global flame residence time; the NO and EINO increased almost proportionally with the increase in global flame residence time. The EINO scaling EINO (ρu e /d) was proportional to Fr 0.42 , which indicated that compared with pure fuel, the fuel diluted with primary air can cause a decrease in the exponent of the Fr power function. At higher pressure, the CO and Emission Index of CO (EICO) decreased proportionally to P −0.35 and P −0.4 , respectively, due to the increased unburned methane and high pressure which accelerated chemical reaction kinetics to promote the conversion of CO to CO 2 .